Comprehensive Review: Optronics LED Clearance or Side Marker Light Video

I was able to go out to the warehouse and measure the mounting brackets holes for the PF11X35W and found that it was 5-5/16 inches or 5.3125 inches. If these aren't an exact match, new holes can usually be drilled into the brackets to make them…

The simplest option would be to install the Correct Track Trailer Alignment and Lift Kit #LC87120 on your trailer. This will allow you to raise the trailer frame from the axle 1-1/4" or 2-1/4". It will also allow you to shift the axle so it…

The big differences is basically pricing and brands. The part #AKFBBRK-35-D is a pair of Dacromet coated drum, hydraulic brakes that are free-backing. The part #40716-15 is essentially the same thing buy made by Demco. The etrailer brand is going to…

Yes, it is possible to convert your 7-way on your trailer to a 4-way. To replace the wiring on your Coleman 10 Foot pop up camper we offer wiring adapters that allow connection of different formats of trailer wiring. The best option to change the…

The brown (running light) wires all run to each other as they carry the same circuit. The reason there is two browns on the trailer side is because there are running lights that are on both sides of the trailer. Aside from that all the rest of the…

As you noted, the typically wiring colors for a 4-Way connector is white for ground, brown for tail/running, yellow for left stop/turn, and green for right stop/turn. The confusing part is that even though this is the typical way that the wiring is…

Thanks for the photo. You will not have any issue using the Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double-Eye Springs #K71-449-00 and moving the equalizer bolt down to the lower hole position. This will work very…

I'd recommend going with the Demco surge actuator part #DM72VR which is designed for a pole tongue trailer like your boat trailer, has a 6k capacity, is designed for drum brakes, and a 2 inch ball. This is our most popular surge actuator for boat…

A 7,000 lb capacity actuator like the part #T47457207K would work great with your boat and trailer that weighs a total of 2,200 lbs. This is a multi-fit coupler that will work with virtually any hitch ball size.

The Titan Actuator part #T47457207K should have came with instructions but sometimes like anything they get misplaced before shipping. With the reverse lock out solenoid basically one of the wires runs to the reverse light circuit of the vehicle and…

I checked with Lippert and their 6k axle uses the bearing numbers 15123 and 25580. Because we know that we know that the Kodiak Disc Brake Kit #K2HR526D will fit your axle since it uses the same bearing numbers. I also attached a couple help articles…

On the Demco Actuator #DM72VR the upper holes are separated by 3 inches and vertically they are 2 inches apart.