Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Replacement Control Unit for Kwikee Electric RV Steps #LC379146 which is part 90950600 you referenced is does not have a specific wiring diagram, but I've attached the closest thing and have also included a video of an installation to…
view full answer...The total height from the mounting flange to the top of the Phoenix Electric Trailer Jack Phoenix Electric Trailer Jack is 22.75". The overall height is 33". I have attached a diagram for your reference.
view full answer...An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. The Replacement Head for Blue Ox SwayPro Weight Distribution Systems part #BXW4011 is for…
view full answer...For a wheel that is 5 inches in width and 15 inches in diameter you would want tires that are size ST205/75-15. For the tire size ST225/75R15 you listed you would want a rim that is from 6-7 inches in width. I attached a department page that has all…
view full answer...From lowest corrosion resistance to highest, the raw steel finish would offer no corrosion resistance whatsoever. E-coat, which is a cross between a painting and a plating process would offer a fair amount of corrosion resistance. Dacromet, which is…
view full answer...Yes, the Dexter Nev-R-Adjust brakes will work with your 3,500 lb AL-KO axles. Brake assemblies attach to the brake mounting flange that is welded to the axle or spindle. The brake mounting flange on the 3,500 lb AL-KO axles uses a standard 4-bolt…
view full answer...The 2x2 inch square axle is likely 3,500 lbs or less capacity. I would need more spindle dimensions or bearing numbers to assist. If you pull a hub and measure at the spindle where the bearings and seal ride using the digital caliper like #PTW80157 I…
view full answer...What a lockout on a hydraulic brake coupler does is prevent the brakes from applying when you back the trailer. An electric lock out is tied into the reverse lamp circuit on the vehicle so that when the vehicle is shifted into reverse the solenoid in…
view full answer...The trailer will have a plate or sticker on it that will list the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that will list the weight capacity. You can…
view full answer...The Kodiak Disc Brake Kit #K2R35S is designed for 3500-lb-rated axles that have idler hubs and allows converting them from idler to disc brake operation. The bolt pattern determines whether they will fit on your idler hubs; and they will fit a #84…
view full answer...There are some Dutton-Lainson trailer jacks that are made in the USA as well as a few that are not. Any jacks that we carry that are made in the USA have that as part of the description to help set them apart. Currently we have the following options:…
view full answer...I would suggested investing into a weight distribution hitch. Even though you are under the towing capacity of your vehicle you will still experience sway and getting a weight distribution hitch will greatly reduce the chugs and jerks that you're…
view full answer...Related Searches
Filter Your Search
Contact and Help