Search: fifth wheel to gooseneck adapter   >   !Trailer Leaf Spring Suspension   >  

The Stromberg Carlson 100 Series Tailgate #VGM-99-100 measures 62 inches across the top, 61-9/16 inches across the bottom, and 21-3/4 inches top to bottom. I have attached a photo showing these measurements for you. These measurements are the same…

The recommended clearance between the rear bumper on your 2018 Chevrolet Silverado 2500 and the body on your 2017 Grand Design Reflection is about 16" - 24" so it sound like you are good. There are also a few other clearance measurements…

The closest metric trailer tire size to a 4.80x12 is going to be a 145/80-12. The typical diameter of a 4.80x12 tire is 20.5 inches. On a 145/80-12, it is 21.3 inches. So the metric size will be a little over 1/4 inch taller. Make sure to measure the…

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

The difference between the 10-10 grease seals, #RG06-090, and the 10-36 grease seals, #RG06-070, is their inner diameter. The 10-10 grease seals fit older spindles with a seal journal (see photo) diameter of 2.125 inches. The 10-36 grease seals fit…

I was able to find the 126003 hub and was able to determine that it is a 3,500 lb hub/drum with a 5 on 4-1/2 inch bolt pattern just like the #AKHD-545-35-K that you referenced. This hub will work as a replacement for your Lippert.

The hole dimensions for the Over the Seal Strap Hinge are as follows. From the center of the hinge to the holes going down the shaft is 3-1/2", 9", and 14-1/2" respectively. So the measurement you're looking for is about 3 inches…

Sometimes the fuses are already installed from the factory, but if not the fuse slots are in the front of the box. I have attached a picture that shows the location of fuse slots. I have also linked a video installation of a brake controller on a…

The Bulldog Replacement Pipe Mount for Swivel Jack - Weld On #BD500339 referenced in your question will provide an attachment point for a pipe-mount swivel jack. The male pipe pairs with the pipe on your jack. The inside diameter of the Pipe Mount is…

On your 2009 GMC Sierra that is equipped with a tow package, the wiring to install a brake controller is already ran from the factory and a plug-in adapter is not needed. You will find a bundle of wires below the dash to the left of the brake pedal.…

For replacement Dexter manual adjust brake assemblies to replace your 36-19 you would want the part #23-27 for the right hand side and part #23-26 for the left hand side. These are manual adjust 10 by 2-1/4 inch Dexter brake assemblies that would…

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…