Will Bulldog Replacement Pipe Mount for Swivel Jack Work with My Trailer Jack
Updated 03/29/2017 | Published 03/28/2017
Question:
Will the Bulldog weldable pipe attachment work with this jack. Part number BD500339
asked by: Thomas R
Expert Reply:
The Bulldog Replacement Pipe Mount for Swivel Jack - Weld On # BD500339 referenced in your question will provide an attachment point for a pipe-mount swivel jack. The male pipe pairs with the pipe on your jack.
The inside diameter of the Pipe Mount is 2 inches and the outside diameter is 2-1/2 inches. You will just need to take these measurements on your jack to ensure this will work.
I have attached an image with these dimensions labeled for you to look at.
Product Page this Question was Asked From
Bulldog Replacement Pipe Mount for Swivel Jack - Weld On - 5/8" Pull Pin
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pipe Mounts
- Bulldog
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Distance From Hitch Pin Center to Beginning of Drop on Draw Tite Ball Mount 40332
- Q&A: Switch Wiring Diagram for Solera Power Awning Switch Kit # LC285500
- Q&A: Replacement Rubber Plug For Ultra-Fab Trailer Jack UF38-944014
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Q&A: Brake Controller Installation on 2011 Toyota Tundra
- Q&A: Parts Needed and Instructions for Installing Brake Controller on a 2019 Jeep Wrangler Unlimited
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Ram Trailer Tow Prep Package
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Trailer Couplers
- Article: Trailer Lighting Requirements
- Article: Determining Trailer Tongue Weight
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)