Dimensions Of The Over The Seal Strap Hinge # PLR2116-SS

Updated 12/14/2020 | Published 12/10/2020

Products Featured in This Question

Over the Seal Strap Hinge - Stainless Steel - 16" Long

(2)

$39.30

Square Corner T-Strap Hinge w/ Reverse Bracket - 270 Degree - 16" Long - Aluminum

(33)

$28.77

Question:

Three questions: 1 do you have the hole pattern layout for this hinge please? 2 is this also available in aluminum? 3 Do you do custom modifications of this hinge?

asked by: Jeff J

Expert Reply:

The hole dimensions for the Over the Seal Strap Hinge are as follows. From the center of the hinge to the holes going down the shaft is 3-1/2", 9", and 14-1/2" respectively. So the measurement you're looking for is about 3 inches from the center of the hinge to the end of the bend. From the center of the hinge to the three holes on the bracket are 1-1/4" for both the top and bottom holes while 2-1/2" for the center hole. We do not modify, these are sold as is. We do have an aluminum one # PLR2216-AS. The stainless steel version will do well with the elements but the aluminum may be easier to modify.

expert reply by: Adam E