Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey John, congrats on the new truck! We can absolutely provide all the parts you need to flat tow your 2026 GMC Canyon AT4. We have the rebuild kit for the Falcon 2 tow bar as well. Here is what I recommend: - Roadmaster Direct-Connect Base Plate Kit…
view full answer...Hey Jerry, when installing the Roadmaster Brake Lite Relay part #RM-88400 the red wire runs to the running light circuit which is typically a brown wire. In the diagram it's being called the taillight circuit but that's same thing as running…
view full answer...Hey Keith. The stainless steal Stromberg Carlson Folding Handrail item #AC-300 is going to be by far the strongest out of those three options. The item #AM-800 and item #AM-300 are both aluminum. The Stromberg Carlson item #AC-300 1" thick,…
view full answer...I spoke to my contact at Curt and they informed me that the reason you are hearing the buzzing noise and the third brake light is flashing when using the Vehicle to Vehicle Tail Light Converter part #C56196 is because the green and yellow output…
view full answer...We have a coiled 7-way to 5-way like with the part #C57271 for a 60 inch long setup. We don't have a 5-way to 5-way though so you'd have to cut off the 7-way and wire in a new 5-way like with the #HM47910.
view full answer...For lighting you can use the diode kit, #RM-15267, and not have to worry about cutting into the taillight housing. This will splice into your taillight wiring to allow your tow vehicle to control the taillight assemblies of the towed vehicle. This…
view full answer...You would need to have an all flat metal bumper on your 1996 Geo Tracker for the Curt tow bar part #C19745 to be able to connect. Since your vehicle does not have that you would need to go a different route. You would need to install a base plate…
view full answer...Hi Steven; I can definitely get you set up so you're ready to go when your new truck arrives. You will need the following parts to flat tow your 2025 GMC Canyon: -Roadmaster Direct-Connect Base Plate Kit - Removable Arms #RM48GR -Roadmaster…
view full answer...Sounds like you are trying to use a diode kit like the Roadmaster Diode kit part #RM-154 to install tow bar wiring on a vehicle with separate function taillights. Running the wiring kit to the front turn signal of the tow vehicle wouldn't work…
view full answer...It would not be economical to have your 2013 Kia Sorento AWD altered to tow with a tow dolly. AWD vehicles usually have 3 differentials so you would at minimum need to remove the rear differential, but most likely also the center differential or…
view full answer...Hey Baihr, In order to fully know if a brake-lite relay is needed for your setup there is a short questionar we recommend going through to determine if you need one. Since I do not have your vehicle in front of me it is a little difficult to tell.…
view full answer...It depends on a few things as it's not a standard difference but typically an incandescent 1157 will pull around 2 amps whereas an LED like the part #CM93236 pulls around 0.2 amp.
view full answer...