Furrion Camera Has Power but Won't Pair

Updated 06/30/2026 | Published 09/03/2022

Products Featured in This Question

Furrion Vision S Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 4.3" Screen

(735)

$479.82

12V PWM Filter for RV Backup Camera Systems - Hardwire

(234)

$68.58

Question:

I cannot get my furrion vision vision S paired. I have a blue light on the camera. I have the monitor inside my truck cab. When I press the pair button, until small clic, for 2-3 seconds, I then push pair on rear camera button on the monitor. It thinks for about ten seconds and then says failed. It works fine if the camera is plugged to the 12 volt plug in adapter, within the truck but nothing behind the camper. I dont know what to do from here to make this rear camera work.

asked by: Avery G

Expert Reply:

The biggest issue we see with the Furrion Vision S Wireless RV Backup Camera Systems like part # FOS43TASF comes from the wiring on the vehicle side, the running light circuit in particular. If it's less than 12 volts then the camera won't be able to pair. The fix for this is a built-in diode, the 12V PWM Filter for RV Backup Camera Systems part # VGR64VR. This is common on new Chevy vehicles and Mercedes.

expert reply by: Conner L

Manuel

6/27/2024

I have the same issue. I also have the 2bolt pwm filter.... Everything worked fine last season. I too the camera off the rear of the trailer over the winter. Reinstalled this year and now camera will not pair. It pairs fine when plugged into the 12 volt outlet dongle. But once removed it loses the pair. When I try plugging it into the rear of trailer I get no pair.

Bryce D.

6/28/2024

@Manuel That's interesting Manuel, I would start by trying to connect the camera directly to the 12 volt power connection on the harness for the monitor. This will help you to verify the camera and monitor are both working correctly. If you are able to get them to connect this tells me you have an antenna issue

Harry

3/30/2025

Hello - I seem to have this same problem, but my silverado is a 2019. Accoring to the spec on the link you have there, that item VGR64VR is for 2021 and up.

Robin H.

3/30/2025

@Harry it looks like some 2019 models also have pulse width modulation so the # VGR64VR would be your solution.

Harry

3/30/2025

@RobinH Thanks - and sorry for the duplicate message just now that was sent accidentally. I may acutally go with this : Part Number: FR87PR

Robin H.

4/1/2025

@Harry sure you can do that too. The # FR87PR plugs in-line with your 7-way instead of being a permanent installation on the trailer.

Bob L.

6/30/2026

I’ve yet to get mine to work either on my 2022 GMC 3500 with a 2022 Keystone Raptor 365 5th and I even bought the pigtail for the truck. Tried it the lights on as well but still will not pair, I’ve never been able to get this to work since buying it ( new )

Claire H.

6/30/2026

@BobL Have you measured voltage at the camera when it's powered on? If it's dropping below 11.5-12V while powered on it may not enter pairing mode. If the camera has proper voltage while its powered, I suggest reaching out to the manufacturer directly to troubleshoot further.