16" x 1-5/16" x 11/16". Low-profile LED trailer tail light serves as a stop, turn, and tail light for trailers over 80" wide. Surface mount - hardware not included. 3-Wire design.
Features:
Specs:
The waterproof construction of this light makes it ideal for use on trailers that may be submerged, like a boat trailer. The housing and lens are sonically sealed together to create a single unit, which means that water will not get into the light and damage the diodes or circuit board.
Surface-mount lights install flat against the surface of the trailer, so a hole does not need to be cut into the trailer for the light. This type of light is installed using a flange or bracket that has mounting holes. And mounting hardware is used to secure the light to the trailer.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today we're taking a look at the Optronics thin line LED trailer tail light. This low profile trailer tail light serves three functions on trailers over 80 inches wide, such as your stop, turn, and tail light functions. It's a sonically sealed waterproof housing and lens unit that is submersible. So this can be completely submersed in water and still operate just fine. It's got a nice waterproof design to it. It is LED.
Now LEDs make great replacements for incandescent lights. They last longer, they burn brighter, and they're more efficient. With an LED system, you don't have to worry about replacing bulbs and you don't have to worry about inaudible 00:00:35 filaments.We're looking at a durable polycarbonate lens and housing, has a nice clear lens over red LEDs. It's compatible with 12 volt DC systems, surface mounts on the trailer, hardware not included. It's a three wire design.
White wire is your ground wire, red is for your stop and turn lights and black is your main power wire for your tail lights. It's FMVSS compliant for trailers over 80 inches wide and it's SAE and Department of Transportation Compliant.Now when it comes to the overall dimensions I measured edge to edge and got a measurement of 16 inches long, top to bottom or side to side is 1-5/16th of an inch, front to back is 11/16th of an inch deep. The mount holes on the unit, there's two of them. One on each end. They're separated on the center by 14.5 inches.
The unit contains a total of 11 LEDs or 11 diodes. We're gonna go ahead and hook this up to power that way you can see what it looks like with power running to it. I will also be able to turn off the overhead light so you can see it in a low light setting. Again, white wire is our ground wire, red is for stop and turn, and black is for the tail lights.So here you can see it sends out a really nice, clear, consistent signal. Again, clear lensing over red LEDs.
When we apply the brakes you can see how that signal output increases and it does the same thing when we activate our turn signals. Again 11 diodes so the multi-diode design really helps optimize the overall light output. Power draw at 12.8 volts is 0.012 amps and Optronics puts a lifetime warranty on the LEDs. That's gonna do it for today's look at the Optronics thin-line LED trailer tail light.
Average Customer Rating: 4.8 out of 5 stars (1107 Customer Reviews)
16" x 1-5/16" x 11/16". Low-profile LED trailer tail light serves as a stop, turn, and tail light for trailers over 80" wide. Surface mount - hardware not included. 3-Wire design.
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.