Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Rick! The Hub Bearing Kit #BK2-100 comes with the Replacement Spindle Washer #5-101. This washer has a 1" inner diameter which will fit your standard #84 spindle. What kind of trailer do you have?
view full answer...Hey Joseph! That is a 3,500 lb Lippert axle so you can use the Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle #BK2-100. If you prefer a Timken kit made in the USA the #TMK52VR is also available. Both come with…
view full answer...Hey Timothy! The brake controller port on the Sprinter is located under the driver seat. The connector picture below will fit into the port and allow you to install a brake controller like the Redarc Tow-Pro Elite #RED52CR. I also linked an…
view full answer...Hello, Phil! We do carry replacement wheel studs. The DeeMaxx drive-in wheel stud part #DE53GR would get pressed in from the back of the camper hub so that you can mount your rim to it. I've included a picture below showing all the dimensions of…
view full answer...Hello Carl, thanks for reaching out. So we do offer a 4" offset gooseneck ball for the 2017 Ram 2500 puck system, the Curt #C68ZV. The problem is this would not be compatible with the Andersen Ultimate hitch. Also, using a double offset…
view full answer...Hello Even, thanks for reaching out. The Dexter 3,500 lb axles use a standard brake size, drum size and bearings so we can absolutely provide what you need. Also, the best way to confirm this is by simply checking the casting number on one of the…
view full answer...I do have one hub that uses a .75" ( #LM11949) outer and a 1.25" ( #LM67048) inner bearing. This bearing combination is uncommon these days, but we have the hub #DX22XR. This is a 5 on 4-1/2" idler hub for a 2,500 lb axle. Bearings,…
view full answer...The DeeMaxx Trailer Wheel Lug Nut #DE93GR is 1.4" in length.
view full answer...A 19 mm socket would be needed to remove the DeeMaxx Lug Nut part #DE93GR.
view full answer...Since the Dexter 10k axles have a 1-1/2 inch threaded diameter the correct replacement nuts would be the #6-96. The tang washer you could use with this would be #5-59.
view full answer...The Dexter 69-46 axle has a straight spindle with #L44649 bearings. For a replacement spindle you can use the BTR E-Z Lube Spindle for 2,000-lb Trailer Axles #TRU44FR. Then for an idler hub, the Easy Grease Trailer Idler Hub Assembly for 2K Axles…
view full answer...In order to find a replacement you will have to identify what you currently have on the trailer. Since you mentioned the rotor I'm assuming you have disc brakes. If you have an over-the-hub rotor you won't need to replace the entire hub, just…
view full answer...