Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I have a replacement option for you, but after reaching out to my contact at Curt I was informed that there are no replacement keys available for your Curt Coupler lock 23521. If you no longer have the keys you will need to go ahead and replace the…
view full answer...Since wheels will be able to withstand the psi rating of any of the tires that are meant to fit it you will need to look at the valve stem as that is the deciding factor. If your valve stem has the rubber all the way up to the threads, like part…
view full answer...I reached out to Taskmaster and the valve stem on the Aluminum Viking Series Valhalla Trailer Wheel #TA75FR is rated for 80 psi. If you need a valve stem with a higher rating, I recommend the Americana Metal, Bolt-In Valve Stem #AM20906 which…
view full answer...In regards to the psi rating for a wheel/tire combo you would always need to abide by the lowest rated component, the tire, wheel, or valve stem. The tire should list the max psi on the sidewall but in order to find this information on the wheel…
view full answer...Although replacement keys were once offered from this manufacturer, they are no longer available. Your only option if you no longer have a key is to replace the coupler lock. For a replacement I recommend the Fastway Universal Trailer Coupler Lock…
view full answer...For the Dexter 4,000 lb trailer hubs the bearings are #25580 for the inner bearing and #LM67048 for the outer. So for a kit that has both you'd want the #BK3-310.
view full answer...Since it is an exact replacement for your original you can just plug in the new Lippert Power Gear Control Panel #LC359259 to your existing wiring harness. Lippert leveling system controls like this are plug-and-play, meaning the new unit should…
view full answer...According to Lippert, all of the parts in the kit should be used. There are, however, some wiring changes that have been made at the pump assembly for the system to operate. The 6-pin wiring harness that you are referencing plugs into the back of the…
view full answer...I'm not sure how old your Lippert Power Gear Manual Leveling System is but the module and keypad design has indeed been upgraded since the original release. The original harness/keypad are no longer made but the Replacement Control Kit #LC359259…
view full answer...The plug that includes the red wire from the Replacement Lippert Power Gear Manual Leveling Control Kit #LC359259 will plug into the back of the control panel and then the other end will plug into the connector coming off of the pump. The other…
view full answer...To upgrade from your 500210 Power Gear Touch Pad you will in fact need the Replacement Lippert Components Power Gear Manual Leveling Control Kit #LC359259, which comes with a new touch pad, 8-pin harness and 6-pin harness. A 4-pin harness will not be…
view full answer...I went out to the warehouse and pulled trailer coupler #CA5400 to measure the latch width and its hole diameter. The latch outside width is just over 7/8 of an inch at 0.88 inches. And the hole diameter is just over 5/16 of an inch at 0.32 inches. If…
view full answer...Related Searches
Filter Your Search
Contact and Help