Result: 67048

The inner diameters of the LM67048 and 15123 both are the same (1.250 inches). That means that a hub with either bearing in the outer bearing would fit your spindle. The part #AKHD-655-6-EZ-K would fit your axle.

The EB01-140 and EB01-145 are Redneck Trailer Supply part numbers for a Dexter 12-1/4 x 3-3/8 7-bolt brake assemblies for a 9-10K axle. The proper replacements are available as part #23-450-451, which includes the left and right self adjusting brake…

In order for the Yakima SweetRoll Kayak Carrier w/ Tie-Downs - Saddle Style - Rear Loading Item #Y04074 to fit, the crossbars you are securing them to must be no wider than 3-1/2" and no taller than 1-11/16". The Thule TracRac #TH27000XT…

The crossbars on a Thule TracRac Ladder Rack are too large for most wrap-around style roof mount bike racks. Therefore, your only option is channel mount roof bike racks like the Thule UpRide Roof Bike Rack part #TH599000 which I like since you…

I may have an option for you, but you will most likely not be able to fit two kayaks with J-style kayak carriers and the Evolution 1800 cargo box on 48 inch or 60 inch crossbars. Instead, I recommend looking at the Yakima Kayak JayLow, #Y04073. The…

The Bearing #29749 has a 1.5 inch inner diameter and the #LM67048 has a 1.250 inch inner diameter. I was able to find the complete assembly for you as Complete Agricultural Hub Assembly #AH30660FCOMP.

The Complete Agricultural Hub Assembly for Spindle AS3000F #AH30660FCOMP has threaded bolt holes for the 1/2 inch Lug bolts that come with the hub. We don't have any that are the same 6 on 6 inch bolt pattern with lug studs, but the lug bolts…

You'll have to pull the hub off and either get me the dimensions of the spindle where the bearings ride or the bearing numbers out of the hub to determine if we have something that will fit. You'll need a caliper to do this. If you get back…

We do have a few idler hub assemblies with threaded lug bolt holes currently available, such as the Redline Complete Agricultural Hub Assembly #AH30660FCOMP. This hub has a 6 on 6 bolt pattern and will fit Spindle #TRU34FR. It has an inner bearing…

The correct trailer hub to use with the Agricultural Spindle part #TRU67FR is the Trailer Hub Assembly part #AH60880FCOMP which features an 8 on 8" bolt pattern. The Dexter Trailer Idler Hub Assembly part #42660UC1 will not fit the Agricultural…

Bearing measurements need to be as accurate as possible, to at least the thousandth of an inch, and require calipers if you have to measure them. Otherwise look at the bearing numbers that are stamped into the sides of the bearings. With those…

We do have the correct wheel stud for your Dexter Trailer Hub and Drum Assembly #8-219-13UC3. This is a 9/16" bolt, and the correct replacement part is the following: - Drive-in Wheel Bolt for Trailer Wheel Hubs - 9/16" Diameter x…