Result: 25520

Hey Marcus, congrats on the new truck! Since your Silverado 3500 has the B&W Turnoverball item #BWGNRK1016, I recommend the B&W Companion item #BWRVK3500. This hitch has a 20,000 lbs capacity and will connect directly to the square gooseneck…

Hey Deven, thanks for reaching out, and good question. For a 12 volt system, the charge controller can handle one 200 watt panel. For 24v systems it can do two 200 watt panels. So while the kit technically is expandable, with your 12v system, the one…

Hey Ron! Sorry to hear that happened. Have you asked them to replace it? The Mighty Cord Replacement RV Power Inlet #A10-30INBKVP door isn't available separately but it can be replaced. You can remove the four screws from the cover which will…

Yes we do, the correct oil seal you would need is the part #10-56 which I verified has same dimensions as the 295924 that you have now.

The hub you have based on the numbers you mentions is the #8-201-9UC3-EZ which is a 6,000 lb axle hub. The grease seal needed then is the #GS-2125DL you mentioned.

The Ram Square 2-Speed Jack part #TJD2SP-12000SP-F does not have any sort of compatible powered drive kit available. That said, if you were to go with the Bulldog Square 2-Speed Jack part #BD183816 you could then use the Bulldog Powered-Drive Kit…

Thanks for reaching out, Linda! If you're able to reuse your motor then I recommend going with the Bulldog 2-Speed Jack #BD183902, but if the motor is unusable then I recommend the Square 2-Speed Jack w/ Crank - Drop Leg w/ Spring Return…

To select proper new hubs for your trailer you will need to confirm a few things: bolt pattern (see linked article), inner and outer bearing numbers (see linked photo) and axle weight rating (which should be indicated on a sticker or plate on the…

Hi Jeff; I'm assuming you were able to identify the parts based on the axle tag or by pulling off the hubs and measuring. Did you verify that the grease seal had a 2.25" inner diameter? The #AKIHUB-655-6-EZ-K comes with a 2.25" ID…

For 1/2 inch trailer u-bolts that attach to axle the recommended torque value is between 45 and 70 ft lbs of torque.

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

Hey Chuck, usually this is a shock problem with surge actuators. The shock isn't allowing the coupler inner member to go all the way forward and release the hydraulic pressure. We have replacement shocks but I would need to know which actuator…