Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Mike, thanks for reaching out. Yes, it will! The Curt Mounting Bracket for 4-Pole Flat Trailer Connector #C42CR will match right up with the Curt No-Drill Bracket #C57202. You won't have to drill any new holes. The picture I included shows…
view full answer...Hey Rick, this is a great question but you would need to leave the tie down off of your 2026 Lexus RX350 when installing the etrailer hitch part #e29ZV. Its not needed but if you were to somehow need to recover the vehicle you could use the…
view full answer...Hey George, congrats on the new truck! You are definitely going to need to support the axle when lifting your Silverado with the Pacbrake Alpha HD Pro Air Bag Suspension Kit item #PB25RV. Lifting your truck by the frame will stretch the bags too far…
view full answer...Hi Janet! I recommend the etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2" #e98850 for your customer's 2005 Toyota Tacoma. This will fit both the X-Runner and non X-Runner models, so it's the one to get.…
view full answer...Hey Wes! You can order replacement hardware for your Curt Hitch using the Replacement Hardware Kit for Trailer Hitches #RHK. However, you will have to identify which hitch you have to get the right hardware. If it looks like the #C13900 then enter…
view full answer...No, I do not Paul and I doubt Curt or Draw-Tite make anything other than a 4-way for the hybrid model. Aftermarket wiring harnesses for vans are typically limited to 4-way connectors like the item #C63RV for LED lights or the item #C32MJ for…
view full answer...Hi Peter! The previous 2025 CX-50 hitch from Curt (the #C33MJ) fit both gas and hybrid models, so I would be willing to bet pretty good money that the new Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" - Preorder #C96UB will as well.…
view full answer...Hey Jim, thanks for reaching out! I see you purchased the curt T-Connector #C56336 to pair with your etrailer Trailer Hitch Receiver #e98901. This will work out great for you, and I'm glad to see you also got the Mounting Brackets #18144 and…
view full answer...It sounds like you are trying to install the Tekonsha Prodigy RF Wireless Trailer Brake Controller part #TK94FR on a 2015 Toyota Highlander that currently has a 4-way flat trailer harness. All you need to do is install the adapter part #37185 by…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...Hey Jason, the #37185 would work great to convert your 4-way to a 7-way while also having a 4-way on the side of for your boat trailer to still use. Does the camper happen to have brakes?
view full answer...I would try to install the No-Drill Mount for Electrical Mounting Bracket part #18140 on the underside of your Draw-Tite Max-Frame Trailer Hitch Receiver part #76138, similar to what you see in the attached photo. The bracket may also need to be bent…
view full answer...