Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…
view full answer...As you can see on the attached photo, the wiring diagram for HydraStar Adapter #HBA-CAM shows there can be a 25-40 amp circuit breaker in-line with the black wiring which goes from the battery's positive terminal to the adapter. I would…
view full answer...Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to…
view full answer...Sorry to hear about the troubles you're having! To remove the Alpha Systems 4034 Roof Coating for RV Roofs #AL34CV from the side of your 1998 Tiago, you can use: - A type of chemical paint remover, - A Paint scraper tool, - A Pressure washer,…
view full answer...The prep you mentioned is more than adequate prior to applying the Alpha Systems 4034 Roof Coating for RV Roofs #AL34CV. According to the instructions you only need to apply the Primer #AL77CV if you're applying this to an EPDM membrane. In…
view full answer...Slipper Springs like #e33SR do not use a bolt and bushing for the open eye end of the spring. It connects directly to the hanger using a slipper spring hanger kit.
view full answer...What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it won't increase the capacity of your trailer as the axle is still rated for that max capacity of 4,400 lbs. My recommendation for…
view full answer...I checked your order notes and the leaf springs you bought last year were the part #e28SR which are for 5k axles. Since this is over the capacity of your axle failure would not have been caused by over loading the trailer assuming you stayed under…
view full answer...Your 2008 Chevy HHR should have a set of rails on the roof that run from front to back. Which means we have the Rhino Rack part numbers #RRVA106B-2 and #RRSX100 as a confirmed fit, but the kit you mentioned is not a fit.
view full answer...Blue Ox has base plate kits that fit your 2023 GMC Yukon XL with the part #BLU54VR which fits the AT4 models with 4L and the part #BLU58FR which fits the non-AT4 models. While we haven't had the chance to shoot an install video for either of…
view full answer...Filter Your Search
Contact and Help