Search: jack foot   >  

Sarge yes, the Aluminum Liger Trailer Wheel #LH35FR will work fine with a 24' camper. These wheels are rated for 1,820 lbs so just a tick under what your current wheels are rated but should work the same. If you'd rather just use a…

Hey TJ, I went out and opened up one of the Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System #LC324269 boxes and found that they include a 5/8-18 x 1-1/2" fine thread grade five bolt. I then called Lippert and they…

The load range tire used is going to depend on the gross trailer weight capacity, which should be on a sticker or plate near the front of the trailer frame or in the trailer's literature. It probably also indicates the load range, or at least the…

To find the proper replacement equalizer for your horse trailer you will need to take a couple of measurements. Measure from the center of the front hole to the center of the rear hole. Then measure from the center of the top hole down to the center…

Despite what the manufacturers of these equalizers say, the axle/wheel spacing isn't the right way to figure out the best fit for upgraded equalizers, including the MORryde CRE3000. The wheel spacing is more of a guideline, so to determine the…

Hello Brennan. The only real difference between the different sumo spring options is the weight capacity or stiffness of the springs. Since you will have a truck bed camper on your 2022 Ram 2500, I recommend going with the 5,000 lb capacity…

When you are replacing bearings you do want to pack them prior to installing the new ones into your hub. This ensures that the grease actually gets pushed completely into the bearings so that they work properly and don't overheat. You can use a…

Dexter Nev-R-Lube Bearings such as the 50MM #31-71-3 referenced in your question do not have a specific maintenance or replacement schedule. These are pre-lubricated at the factory, which will make it resistant to contamination, and sealed for life…

I spoke with my contact at Dexter and he said the 21-37 oil cap is obsolete and was replaced with the 21-36 oil cap, #RG04-270. This cap includes the o-ring and plug.

With the 1/2 inch diameter wheel studs on your etrailer.com Idler Hub Assemblies #AKIHUB-545-35-K and the 15 inch steel wheels from the Loadstar Tire and Wheel #AM3S640DX, you are looking at a torque spec of 90-120 ft.-lbs for the lug nuts. I have…

The Ark Drop Down Corner RV Stabilizer Jacks #AR34FR are designed to be welded on, so this is the only way we can recommend installing them. With the included mounts there really is not enough room between the stabilizer itself and the mounting plate…

The Lippert Components 5th Wheel RV Landing Gear Foot Pad - 9" Round #LC314667 is compatible with your landing gear leg. The Replacement Front Foot Pad for Lippert Components Ground Control 3.0 Leveling System #LC362486 will work for your system…