Result: 68149

Hello Mike, thanks for reaching out. The Replacement Shock for Dexter Model 6 and 10 Brake Actuators #T1242600 may work for you, but we do not carry the Gabriel brand, so the information available to me about their parts is limited. Basically, the…

Hey Andy, the Ventline Roof Vent part #V3092-603-00 does not include a garnish. You can pair this with either the Polar White #VA0445-33 or Birch White #VA0445-25 ceiling garnish which is designed to fit roofs 7/8" to 2" thick. How thick is…

Hello Darin, thanks for reaching out. I do have a solution for you. What I recommend is the Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00. This is made for trailers with drum brakes, and it attaches to a 2" ball. It does not come with an…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hi Cindy, Are you wanting to transition to electric drum brakes or would you just like to switch to an electric-over-hydraulic (EOH) setup that you'd be able to use a brake controller? If you want to switch to electric drum brakes you'll need…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

Hey Dylan, thanks for reaching out! Your UFP HD1377 drums will fit with a 10" brake assembly which means you can use the Replacement Wheel Cylinder #AKBRKR-H7-R for the right-hand (passenger side) or the Replacement Wheel Cylinder #AKBRKR-H7-L…

From my research, the correct replacement for the UFP HD1377 hub/drum is the Trailer Hub and Drum Assembly part #AKHD-545-35-K or the Dexter 5 on 4-1/2 Complete Hub-and-Drum Assembly part #84546UC3. These hub/drums both use a L68149 (1.378"…

To determine if the Replacement Shock for Titan Model 6 and 10 Brake Actuators, part #T1242600 will work to replace your Gabriel number 610712 (T2032) shock, you will need to verify a few quick measurements. Part #T1242600 will work as a replacement…

Based on previous information we have for your UFP HD-1377-10 hub it uses the following components. I do recommend pulling one of your hubs to verify that the replacements listed below match your current parts. Inner Bearing #L68149 (Inner diameter…

The only thing I found on your Dexter 70-7 is the Replacement 13" Rotor for Dexter Disc Brakes #K71-631-00 which has 70-7 stamped on it. The #K71-631-00 fits 8,000 lb. Dexter disc brake kits like the #K71-646-2, #K71-646-2-91 or #K71-646-2-90.

This is a fairly straightforward install. GM has already run some of the necessary wiring from the rear frame rail area to the engine compartment, so you will see a blue wire for the electric brake function, and an orange wire which provides 12 volt…