How Can I Remove RV Roof Coating From The Side Of My RV?

Question

Question:

i put alpha 4034 on my 1998 Tiago 31 foot motorhome and a rain shower came with no warning. of course it washed all off it off and down the sides. what is the best way to get it off the sides?

asked by: Ricky D

0

Expert Reply:

Sorry to hear about the troubles you're having!

To remove the Alpha Systems 4034 Roof Coating for RV Roofs # AL34CV from the side of your 1998 Tiago, you can use:

- A type of chemical paint remover,

- A Paint scraper tool,

- A Pressure washer,

Or

- A Knife to scrape it off.

expert reply by: Bryce D

0

Answer 1

Hey Ray! Since you tried out a different vehicle and had the same issue we can rule out the vehicle side. The first thing I would do is check your ground connection and make sure it is secure. After that, I would go ahead and hook it up, run your…

view full answer...

Answer 2

Hey Alex. From the information I can find online it does look like your 2011 Keystone Cougar 318SAB does come prepped for a second AC unit. The bedroom roof vent should be reinforced and pre-wired for a 13.5k or 15k BTU unit. To check if your trailer…

view full answer...

Answer 3

Hey Jack, thanks for reaching out. The Dylux RV AC w/ Heat Pump #DY27FR comes with a 2-year warranty from Dylux. That warranty covers the air conditioner system itself, including the rooftop unit and related components, against manufacturing defects…

view full answer...

Answer 4

Hey Rodney, For a rubber roof you can use the Alpha Systems 1021 Self-Leveling Sealant for RVs #AL98KV. This is self-leveling sealant so it's design to pool a bit before drying and would only be good for use on the roof. If you're needing any…

view full answer...

Answer 5

Hi Craig! The Replacement Shroud for Dometic Brisk RV Air Conditioner - Polar White #DMC27BQ is not the correct replacement shroud for you Brisk II air conditioner. Instead, you should use Replacement RV Air Conditioner Cover for Dometic Brisk Air II…

view full answer...

Answer 6

Hi Jeong-Won; the Dexter DX7.5L A-60 Brake Actuator w Electric Lockout #DX89FR fits a 3" wide trailer tongue without a specific height requirement. To add a hinge back onto the tongue you simply have to measure the height. If you have a 3"…

view full answer...

Answer 7

Hey Kevin. For a Dexter 89-3 caliper you'll want to use the Dexter Semi-Metallic Disc Brake Pads - 6,000 lbs to 8,000 lbs item #K71-629. This kit includes four brake pads and mounting hardware to replace one axle's brake pads. If you have any…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Answer 10

Hi Ray! The MORryde GooseTech 5th Wheel to Gooseneck Pin Box for 11.5K to 14K Trailers #MR74MV can definitely be used in a short bed 3/4 ton pickup, like your 2024 Ram 2500. Just be aware that not all trailers have a tapered nose and you may not get…

view full answer...

How Can I Remove RV Roof Coating From The Side Of My RV?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching