Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Demco Hijacker Autoslide 21K #DM8550038 weighs approximately 305-lbs. The head of this hitch weighs around 70-lbs and can be removed to help make moving and installing this 5th wheel hitch a little bit easier.
view full answer...Due to the fact that carbon fiber bikes have a more sensitive frame, Thule does recommend using the Thule UpRide #TH599000. Bike rack technology has not changed to make the racks less compatible, but carbon fiber bikes have become increasingly…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…
view full answer...We have a full replacement for your light. The Command Electronics #CE86FR. Take a look at the attached video to see them in action.
view full answer...The first thing to do is disconnect the trailer from the Liberty. Then using a circuit tester, like part #PTW2993, test each pin of the 4-Way. Clip the alligator clip of the circuit tester to the exposed post, the ground wire. Check each pin with the…
view full answer...The closest modern tire size to a 7.00-15 tire is a 225-75-15 like the #AM10256 tire you mentioned. Typically, a 225/75-15 tire will measure about 8-3/4 to 9 inches wide by around 28-1/2 inches in diameter. We offer the same size in a Load Range E as…
view full answer...If you are looking for the center section of the bracket that is in the picture you submitted of the #MCL67ARB that you referenced the correct part number you need is the #A65P that you referenced.
view full answer...In order to choose between the Dexter E-Z Flex Suspension Kits, part #K71-652-00 and part #K71-653-00 you simply need to measure the existing equalizers. If they measure 5-1/2" or close then you'll use part #K71-652-00 but if they measure…
view full answer...Based on the dimensions you listed we have the part #010-180-00 which would fit and work well. This has an outer diameter of 2.33 inch and an inner diameter of 1.68 inch like you need so it would work well.
view full answer...Both automobile and trailer standard brakes lines are made of steel tubing like #T4336000. This item has a 3/16-inch diameter and the steel line is both copper-plated and galvanized for resistance to corrosion. Boat trailers can also be equipped with…
view full answer...I did some digging on your AL KO 7,200 lb axle and it has bearings #28580 and #25580 which means you have a 99 spindle. The only hub we offer that will fit this setup is the part #99865UC3 which is a similar Titan hub but has an 8 on 6-1/2 inch bolt…
view full answer...I do have some good replacement options for you although you'd have to drill a few new holes for mounting as none will line up with what you have now as the model is discontinued and there are no direct replacements. I recommend the Dexter DX7.5…
view full answer...Filter Your Search
Contact and Help