bing tracking image
Q & A Icon

Trailer Mate Hitch and Spare Tire Access on Toyota Highlander  

Updated 09/22/2026 | Published 09/19/2026

Question:

You said the spare tire was really close to the hitch, do you still have access to the spare?

0

Expert Reply:

Yes, Tim, you will still have access to the spare tire as long with Trailer Mate hitch part # TMT67FR as long as you have an 18 inch or smaller spare stored under the vehicle. Larger or full size spare tires will not be able to be stored underneath the vehicle with this hitch. If you have an 18 inch spare, you can keep it under the vehicle and still easily access the tire hoist to lower it when needed without the hitch or its hardware getting in the way.

The Trailer Mate hitch is a nice choice because it is easy to install and has that clean, concealed cross tube design that gives it an almost OEM look. I’ve also attached an installation video so you can see how everything fits and how the spare tire access works.

If you are planning on towing, you can pick up some wiring part # C56RV to light up the trailer lights, depending on if your Highlander has a factory wiring or not.

The two easiest ways to tell if your Highlander has the factory tow wiring are to check behind the driver side paneling near the third row seating for the factory connector that the Curt C56RV module plugs into, or contact your local Toyota dealer with your VIN. They can look up the vehicle’s original equipment and confirm whether the factory tow wiring is present.

Are you planning on doing some towing or using the hitch for a bike rack?

expert reply by:
0
Heather A
h2
h2
(click to enlarge)
h
h
(click to enlarge)
Pnw T. profile picture

Pnw T.

9/20/2026

Yes, you can still access the spare. I already had to since installing the receiver. My advice - pay attention to where you mount the wiring harness. The wiring bundle off the 7-way kit (#ETBC7L) does interfere but not prevent the spare tire removal. I mounted the 7-way kit a couple inches left of the receiver and now I can't drop the tire straight down as designed. I have to angle the tire while managing how it clears the bundle - keep the forward edge of tire angled down, rear end of tire angled up while raising/lowering it from the fully seated position. Nothing too hard, but it might have been better to mount the 7-way outlet further to the left. FYI - I purchased the 7-Way RV Upgrade Kit (#ETBC7L), Deka Heat Shrink Butt Connectors (#DW05745-5), and T-One Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector (#TK74FR). The hardest part was the self-taping mounting screws in the upgrade kit were insufficient for the strength of the receiver. The heads kept breaking off BEFORE fully seating when trying to tighten the bracket down. I had to drill out the screw left in the hole and use stronger mounting screws.

Heather A. profile picture
Etrailer Expert

Heather A.

9/22/2026

@PnwT Great advice! It’s always helpful to hear how the 7-way wiring actually sits in the real world, especially since a little extra clearance can make dropping the spare much easier. Hopefully you won’t have to wrestle with that spare again anytime soon! Thanks for sharing all the details to help the next person.

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>