Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
The Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal uses 16 LEDs to put out a bright amber light that draws very little power. At 12.8 volts, it only pulls 0.074 amps for the side marker and 0.248 amps for the turn signal. The faceted Miro-Flex reflector design spreads that light evenly and gives it a sharp, modern look. With no bulbs to replace and no fragile filaments, the LEDs last up to 50 times longer than incandescent lights.
If your trailer sees rain or gets launched at the ramp, this light is ready for it. The housing and polycarbonate lens are sonically sealed into one solid piece, so water can’t leak in and wreck the circuit board. It’s fully submersible and stays reliable through wet roads, washes, or dips into the water.
Wiring this light is straightforward. It uses a 3-wire pigtail with 20-gauge wires—white for ground, black for running light, and red for stop or turn. That setup gives you two light levels: a low intensity for running lights and a brighter one for turn or brake signals. It works on trailers that have separate circuits or can be adapted with a converter if needed.
Measuring 6" long x 2-1/4" tall x 1-3/8" deep, this rectangular light mounts flush to flat surfaces using holes spaced 4-13/16" apart. There’s no base required; you just provide your own mounting hardware. The amber lens looks sharp while keeping visibility high from the side or mid-ship position.
With its P2 rating, the beam shines out at a 45-degree angle from centerline for clear forward visibility as a side marker or clearance light. It’s bright enough to catch attention yet controlled so it meets proper lighting coverage on trailers that need a mid-ship turn signal or marker light in one unit.

Customer Satisfaction Score:
99% were satisfied with this product
1% of customers were not satisfied
Ratings & Reviews

Jenny N.
4/16/2023
I wanted to give you more information on the light. The LED board is sealed so that water will not be able to enter inside the light. It does have a lifetime warranty on the LEDs so if they go out the light will be replaced by the manufacturer. Typically, hardware nor instructions are included, however I can tell you that thew white wire is the ground, the red wire is stop and turn, and the black wire is the running light circuit.

Leroy
9/23/2021
I installed them on my trailer cause I felt that I needed to a turn signal on side of my 38 ft trailer. I like them very much.
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.






William
8/21/2022
About the same. Still not thrilled about the brightness but I havent switched them yet.