Is the Bezel Included w/ the Miro-Flex LED Trailer Side Marker?

Question

Question:

Hi, Does your stock below come with a chrome color bezel? or just the light. [ Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal - Submersible - Amber Lens ] Item # MCL48AB Thank you!

asked by: Jay L

0

Expert Reply:

Thanks for the picture! The Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal item # MCL48AB only comes with the light not the chrome colored bezel in your picture. The bezel is available to be purchased separately it is the Chrome Bezel for Optronics MCL48 and MCL73 Trailer Light item # A48CB.

expert reply by: Jerred H

0

Miro-Flex LED Trailer Side Marker Light
(click to enlarge)

Answer 1

The issue you are experiencing is due to the fact that your trailer has separate trailer wiring circuits, meaning the turn signals and the brake lights are on separate bulbs and the trailer wiring harness #C56496 you installed is designed to operate…

view full answer...

Answer 2

You can absolutely connect the 14 gauge and 20 or 18 gauge wires, you'll just want to be extra sure the butt connectors you use to connect from the junction box wire to the lights is secure since you're connecting two different gauge wires.…

view full answer...

Answer 3

Your problem is in the wiring in one of two places. It is either on the vehicle wiring harness or somewhere in the wiring on the trailer. The first thing to do would be to narrow it down to one of these two places, then we can pin-point the problem…

view full answer...

Answer 4

All the 2014 Chevrolet Silverado's should have the factory wiring for a tow package. The 7- and 4-Pole Trailer Connector Socket #HM40975 is the most commonly used part as it will fit right into the factory cutout in the rear bumper and gives you…

view full answer...

Answer 5

In order to determine the correct replacement light bulb for the isle light in your 2008 Forest River Berkshire Motorhome, I would need to know the bulb type and size. In order to find the bulb type and size you will need to remove the plastic cover…

view full answer...

Answer 6

Hey Chuck, the cut-out dimensions for the Vitrifrigo DP2600IXD4-F-3 refrigerator #VT96FR are 52.9 inches in height and 23.4 inches in width. The depth for a flush mount is 23.69 inches. Would that work in you RV?

view full answer...

Answer 7

To determine if there are compatible hubs and associated bearings to replace your current hubs to a more standard size you will have to take several precise measurements on the spindle of your axle. It is recommended to use a set of dial calipers to…

view full answer...

Answer 8

I attached a link to this page that has all of the tire and wheel combos that are aluminum that match your tire size of ST235/85R16 with an 8 lug bolt pattern. For a higher capacity option that looks really nice we have the Provider ST235/85R16…

view full answer...

Answer 9

To remove bulbs from the Round Trailer License Plate Light with Mount Ears - Chrome Plated #LP71CB, you simply remove the screws on the outside mount, remove a plastic dome and rotate the bulb to remove. The bulb is a CT67. We don't have any LED…

view full answer...

Answer 10

I have a solution for you, but the Round Trailer License Plate Light with Mount Ears - Chrome Plated #LP71CB does not come in an LED light version. However, the LED Trailer License Plate Light Kit with Bracket - Submersible - 2 Diodes - Clear Lens…

view full answer...

Answer 11

You are correct. When you set up the brake controller for the first time, you set the power to 6 with no boost, drive the vehicle and trailer on a flat surface at 25 mph, then fully apply the manual override. Adjust the power as needed to reach a…

view full answer...

Is the Bezel Included w/ the Miro-Flex LED Trailer Side Marker?

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching