2007 American Heritage Clearance Light Replacement
Updated 05/20/2021 | Published 05/19/2021
Question:
I need some marker lites. Says TMC 446 on lite. Approx 6 3/4 inches overall. 6 1/8 between screw holes.
asked by: Mark
0
Expert Reply:
If you'd be okay with drilling new holes you could use the Miro-Flex clearance light part # MCL48AB which is 6 inches long and has mounting holes that are 4-13/16 inches apart but we don't have anything that matches perfectly.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal - Submersible - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 6L x 2-1/4W Inch
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Setting the Power Output and Boost Settings on a Tekonsha P3 Trailer Brake Controller
- Q&A: Troubleshooting EOH Brakes With Hydrastar Actuator Not Working With 2024 Ford F-450
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: How to Install Brake Controller Wiring on a 2008 Toyota Tundra SR5 Crewmax
- Q&A: Replacement Amber Trailer Light for GloBrite 1250
- Q&A: Replacement Camera System For Furrion Vision FRC12TA-BL
- Q&A: Can Single Rocker Switch # 37212625 be Used with 12 Volt DC Power
- Q&A: Oil Bath or Grease for HydraStar Disc Brake Kit with Actuator for Tandem Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Carrying on a Legacy: One Family’s Story of Grief, Growth, and a Global Pandemic
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Maintenance Schedule
- Article: Basics of Tie Down Straps