What is the Wire Gauge on Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal
Updated 12/28/2023 | Published 12/26/2023
Question:
What wire gauge are the 3 wires on this side marker. Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal - Submersible - Amber Lens Item # MCL48AB Thank you
asked by: Phil
0
Expert Reply:
The Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal # MCL48AB uses 20 gauge wire.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Miro-Flex LED Trailer Side Marker Light and Mid-Ship Turn Signal - Submersible - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Submersible Lights
- LED Light
- 6L x 2-1/4W Inch
- Amber
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Setting the Power Output and Boost Settings on a Tekonsha P3 Trailer Brake Controller
- Q&A: Troubleshooting EOH Brakes With Hydrastar Actuator Not Working With 2024 Ford F-450
- Article: Trailer Lighting Requirements
- Article: Trailer Wiring Diagrams
- Q&A: Can Single Rocker Switch # 37212625 be Used with 12 Volt DC Power
- Q&A: How to Install Brake Controller Wiring on a 2008 Toyota Tundra SR5 Crewmax
- Q&A: Replacement Amber Trailer Light for GloBrite 1250
- Q&A: Replacement Camera System For Furrion Vision FRC12TA-BL
- Q&A: Oil Bath or Grease for HydraStar Disc Brake Kit with Actuator for Tandem Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Carrying on a Legacy: One Family’s Story of Grief, Growth, and a Global Pandemic
- Article: Converting Your RV Water Heater to Tankless
- Article: Trailer Maintenance Schedule
- Article: Basics of Tie Down Straps