Replaces the door sensor used to override the automatic retraction on your Kwikee powered RV entry steps. Round tabs mount on the door and doorframe. Wire to steps to stop retraction when they come into contact.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hello, neighbors, Steven here with etrailer.com. Let's take a look at our replacement magnetic door sensor for the Kwikee electric RV steps. Now, folks, these simply replace that door sensor tabs for your Kwikee electronic RV steps. You get the two round tabs here, the wiring and the mounting plates. If you're not familiar, basically, these mounting plates go onto the RV door and door frame. This sensor would then get pushed in place.
I'm not gonna push it all the way in there because it would snap in with these tabs and most likely not come out. But then, whenever these touch each other, then that would stop the retraction of the steps. It is made here in the U.S. As far as some quick dimensions, these tabs are an inch diameter, an inch and 1/8 long, or deep, however you wanna say it. The mounting plates, they are 1 3/8 inches center to center on the mounting hole pattern.
And the wiring is 18 1/2 inches long. Well, folks, that's gonna wrap it up for our quick look. Just a set of replacement magnetic door sensors. I hope this information's been helpful for you in your purchase today. I'm Steven.
Have a good one.
Ratings & Reviews
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.







Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.