Result: trailer reverse lights

According to Dexter, this is a 3,750 lb torsion axle with a 90.3" hub face measurement. More than likely your axle uses #L68149 and #L44649 bearings with a #168255TB grease seal. You will need to verify this information since Dexter did not have…

Hello Xiaoming, Yes, we do have the Dexter K71-622-00 available, though it's under a different part number for our site. What you need is the following: - Dexter Replacement Trailer Axle Spindle Retainer Kit #DX82CR This includes two D washers,…

Thanks for sending pictures! The titanium shims you installed are just fine, but note that the inch of play is absolutely normal per my contact at Cequent Corporation. The Fulton Fold-Away coupler hinge kit you referenced is most likely very similar…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

The closest option we have available to your existing round Glo-Brite assemblies (which are no longer made) is the Optronics LED Trailer Tail Light #STL13RFHXB. This assembly has an overall diameter of 5-5/8" and the light face itself measures…

Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.

Is there a solenoid screwed in to the back of the master cylinder on the trailer? Or is there a lever on the actuator that you move whenever you need to be able to back the trailer up? If so, then you have a reverse lock out. I attached a link to a…

The best thing to do to determine if this is the correct hasp for your 2000 Haulmark is to measure. I have linked an image with the measurements of the Polar Hasp #158-101 to this page for your convenience. The center on center mounting holes are…

The GloLight LED Backup Light for Truck or Trailer #BUL111CFPG is submersible and very bright so it would work great for your boat trailer application.

The lid of the Junction Box part #3375601101 that you referenced does not have an O-ring or seal built into it. The lid has a pretty deep channel though that fits to the base of the box well enough that it does a decent enough job keeping moisture…

So in order to add a reverse light to your boat trailer, all you need to do is connect the wiring from your junction box or 7-way directly to the reverse light's wires. For reverse lights, if you don't already have wiring at the junction box…

The yellow wire of the 7-way harness part #H20044 that you referenced goes to the center pin of the 7-way which is an aux circuit that is typically used for reverse lights if present on the trailer. Normally the red wire on a 7-way (RV standard…