Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
I spoke to my contact at Dexter Axle, they told me the Dexter Axle Torflex #10 Axle Side-Mount Frame Installation Hardware Kit #DX54FR is made of steel. They also said that there is not an aluminum alternative.
view full answer...Dexter part 10-41 is a grease seal for a mobile home utility hub. It has a specified inside diameter of 1.938-inches and an outside diameter of 2.523-inches. The nearest match we offer is the Redline part #10-40 which is a single-lip seal that has…
view full answer...You wouldn't use a spring like #RS16933LH because it produces 2,000 foot pounds of torque and you would not be able to open the ramp. What I recommend is either the Rack'em Double Barrel tailgate assist, #RA-27C. The Double Barrel will reduce…
view full answer...I have attached a photo of the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C89UR fully installed on a 2021 Toyota Venza. This is a great hitch choice, as these come with a strong rust-resistant powder coat paint. All hardware is…
view full answer...I checked with Curt and they did confirm the hitch part #C89UR as a fit for the 2023 Toyota Venza.
view full answer...The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…
view full answer...According to my calculations the distance from the center of the pin hole to the far end of the shank on Curt combo bar #E-9 is 3-1/2 inches. The bar is 6 inches long overall so from the center to the face of the receiver is 2-1/2 inches.
view full answer...I went to our warehouse to pull the Curt combo bar #E-9 to provide some measurements. And yes, the Curt combo bar #E-9 will have an internal dimension of 2-inches x 2-inches and outer dimension of the shank is 2-1/2 inches x 2-1/2 inches. The forged…
view full answer...The outside diameter of the Gen-Y Weld-On Receiver Tube #325-GH-002 is 2-9/16 inch by 2-9/16 inch behind the collar.
view full answer...Yes, we do offer 2-1/2" to 2" trailer hitch reducers like the B&W Hitch Receiver Reducer Sleeve part #BWRHXA2182 which is what I recommend. That said, they all have some play so if you are trying to get rid of this completely a…
view full answer...Using a Hitch Sleeve Reducer #BWRHXA2182 or #BWRHXA2183 will not reduce the capacity of your receiver. You will need to ensure you do exceed the weight capacity of the ball mount or other hitch mounted accessory that you are using. A sleeve like the…
view full answer...I recommend the Thule Helium Pro 3 Bike Rack - 1-1/4" and 2" Hitches - Tilting - Aluminum Part #TH9043PRO. With its lightweight aluminum construction, the installation is easy, and it will allow you to free up some weight for your activity…
view full answer...Related Searches
Filter Your Search
Contact and Help