Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…
view full answer...A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…
view full answer...For a B&W 4 inch offset ball that will fit a B&W Turnover Ball gooseneck hitch on your 2015 GMC Sierra 2500 you will need #BWGNXA4085. I have linked a video review of this ball for you.
view full answer...Though I do have an alternative option available, we do not carry the Coleman Mach line of AC units. We do occasionally have used parts listed, but unfortunately, internal parts for these cannot be mixed and matched between manufacturers. With that…
view full answer...From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…
view full answer...For all intents and purposes, yes, the Fulton drop leg stabilizer jack SJL80300 is the same as the square leg jack you asked about: - Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs #SJ-R208 Different manufacturers but otherwise they…
view full answer...We do not offer wishbone wiring that has a ground wire going down both sides. You really don't need it because the ground wire is for the plug itself not the lights and you want the ground close to the plug. I recommend using the 4-Way Wishbone…
view full answer...According to Lippert, the mounting nuts should be torqued to 120 ft-lbs for the Axle Riser Kit - Single Square Torsion Axle - 3-1/2" Lift #LC382741.
view full answer...I attached a link to this page that has the install instructions for the Axle Riser Kit #LC382741 that you referenced.
view full answer...According to your owners manual, you can absolutely flat tow your specific model. It is not recommended to tow this vehicle over 65 mph. You will also need to start the engine and allow it to run for five minutes at the beginning of each day and…
view full answer...I have a solution for you, however, the jack that you referenced will not fit a 5 inch trailer tongue. The Fulton Bolt-Thru Swivel Marine Jack, #FXP15, will fit 3 inch x 5 inch trailer tongue and has a lift capacity of 1,500 lbs. This Fulton jack is…
view full answer...Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have are…
view full answer...Filter Your Search