Can I Bypass Lippert Stabilizer Jack Switch To Test Switch Functionality
Updated 09/26/2022 | Published 09/25/2022 >
Products Featured in This Question
Question:
I believe my switch for Lippert stabilizer jack is bad. The jack went down but will not retract. It had gotten iffy in both directions over past couple of months but worked in both directions. Is there a way to splice the wires perhaps the red to the yellow to reverse the jack to bypass the switch and verify it is probably a bad switch?
asked by: Alan Z
Expert Reply:
To bypass the switch that came with the Lippert High-Speed Power Stabilizer Jack # LC298707 you can definitely grab the 12V power wire (red wire on switch) from your battery and apply it directly to the yellow "retract" wire to see if the motors operate just fine. You can also verify that the jacks themselves work just fine without power by using the manual crank # LC119226 if applying power to the "retract" function doesn't do anything.
If you find that the switch is the problem then you can replace it with part # LC387874. If applying power directly to the motors doesn't cut it then the correct replacement motor is part # LC352338.
Attached are some review videos for you to check out.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: stabilizer motor
- Shop: Replacement Electric RV Stabilizer Jack Motor for Lippert Landing Gear
- Video: Review of the Replacement Electric RV Stabilizer Jack Motor for Lippert Landing Gear
- Search Results: motor
- Shop: Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor
- Video: Lippert Components Trailer Jack LC138445 Review
- Video: A Closer Look at the Lippert High-Speed Power Stabilizer Jack
- Shop: C-800 Replacement Klauber Motor for Standard Lippert Electric Stabilizer Jacks
- Q&A: Replacement Gearbox for Lippert High-Speed Power Stabilizer Jack
- Q&A: Replacement Motor for Lippert Stabilizer Jack # 113407
- Search Results: led lights
- Shop: Optronics Flexible LED Light Strip - Weatherproof - White - 17' Long
- Shop: Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Video: Review of the Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
- Shop: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
- Video: Review of Dicor RV Roof Repair - Lap Sealant Ivory - DC34SR
- Shop: Replacement Motor and Gear Box Assembly for Lippert Components PSX2 Electric RV Stabilizers
- Video: What to Know About the Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Search Results: x chocks
- Search Results: lap sealant
- Search Results: dicor
- Search Results: proflex
- Q&A: Lippert Stabilizer Jack # LC298707 Mounting
- Q&A: Spacers for Lippert Power Stabilizer Jack
- Shop: Gooseneck Hitch
- Q&A: Replacement Motor for Lippert Components PSX2 Electric RV Stabilizers
- Q&A: Replacing Chewed Up Power Wires On A Lippert PSX2 Stabilizer Motor
- Video: A Closer Look at the MORryde StepAbove RV Steps for 27-3/4" to 30-1/4" Wide Doorways
- Shop: Fifth Wheel Hitch




