Hey Mark, thanks for all of the info you listed about your hub. With just that info we know that the hub/drum part #AKHD-655-35-EZ-K that you referenced is an exact replacement.
I reached out to Lippert and my contact was able to confirm that the hub bore on you 176207 4,400 lb axle is 2" which means you can use the Replacement Dust Cap #DC200L-DCRP or get it in a 2-pack as part #RG04-040.
I am not sure what size would work best but we do have the Labeled Single Slide-Out Momentary Switch - On/Off/On - White #37213445 which would work great as a replacement for what you have now. This needs cut out dimensions of 1.85" tall x…
The etrailer Trailer Hitch Receiver #e98843 for your 2020 Hyundai Santa Fe has a measurement of 5inches from the center of the hitch pin hole to the most outward part of the rear bumper. I attached a diagram showing that measurement and an…
We have not yet installed the Adjustable Width Trailer Hitch Receiver part #13703 on a 2014 Heartland Big Country but so long as the frame rails are spaced between 22" and 72" apart which they should then this hitch will work for you. It is…
The Dexter "8-248" is a hub assembly for 3,500 lb axles that uses an L68149 inner bearing and a L44649 outer bearing. This hub assembly was offered in both 5 on 4-1/2" and 5 on 4-3/4" bolt patterns therefore you would need to…
You mentioned grease seals for your 5,200 lb Lippert axle, which we do have, but since you also mentioned mating with bearing #25580, I'm not sure if you were possibly referring to the bearing races, so I'll just go ahead and give you both…
There is not a standard air pressure for all ST205/75D15 trailer tires as the different load ranges will require different air pressure. They could also very well vary from manufacturer to manufacturer. However, the air pressure rating for a trailer…
We do have the exact replacement you need for your Dexter 008-249-07 hub, with the complete kit, which includes the hub and drum, bearings, race, and grease seal being the following part: - Dexter Trailer Hub and Drum Assembly for 3,500-lb Axles…
Retainers are not included with the Replacement Bug Screen for MaxxAir II RV and Trailer Roof Vent Covers #MA10-20121. This part comes with just the screen, which will snap into the vent cover.
The correct big screen for the MaxxAir II RV and Trailer Roof Vent Cover part #MA26JR is the Replacement Bug Screen for MaxxAir II RV and Trailer Roof Vent Covers part #MA10-20121.
Filter Results
