The only repair option we have is total replacement with a coupler like the #CA-5210-B you were looking at. Unfortunately, we do not have a latch repair kit for this latch style.
Hey Karl, so as long as your current wheel bolt pattern is 8 on 6-1/2 inch you can mount a 17.5 inch wheel and tire like the Westlake 215/75R17.5 part #LHAS701. The width and diameter of this size is going to be right at the same as your 16 inch…
We don't currently carry the Covenant brand so we don't have replacement parts and you would need to reach out to the manufacturer directly. That being said, from my experience with RV fireplaces the manufacturer's typically will not give…
The Gen-Y Anti-Rattle Clamp for 2-1/2" Hitch Receivers #325-GH-063 will work well as long as you have the between 7/8 inch and 1/2 inch between the receiver collar and the drop shank. The Anti-Rattle will wedge between the mount and the receiver…
The Peterson Clearance and Side Marker Trailer Light #M152R will be the closest option we have for you. The 2 inch lens has male terminals on the back which accept a 2-wire female plug. If you need the Amber Light you will need the #M152A. If you…
We do have actuators that will work with a trailer that has disc brakes and an 8,000 lb GTW. The Titan #T4747200 may be a great option depending on the hitch ball size you need. It works with a 2-5/16" hitch ball, bolts onto 3" wide channel…
The correct replacement breakaway lever for your Titan Model 6 Zinc-Plated Brake Actuator part #T4747200 is the Replacement Breakaway Lever with Pin for Titan Model 6 Actuators part #T4594100. In regards to installation, this will be up to you as…
I recommend replacing your Atwood coupler with a Demco A-Frame Trailer Coupler #DM14791-97, as parts are virtually impossible to find for the older Atwood couplers. This will get you all new latch components that feature an EZ latch system. The…
Since the trailer connector on your 2013 Ford F-150 is no longer sending power to the turn signal circuits on your trailer you will need to replace fuse #73. This 20-amp fuse is located in the engine bay fuse box and is what sends power to the…
The Trailer Coupler Lock #e98887 will work with a UFP A-60 coupler like your Dexter A-60 #DX56FR. The product picture for this lock shows it being used on an A-60.
It sounds like you might be trying to pick out a set of stabilizer jacks for your trailer. If that is the case then what you will want to do is park your trailer on flat-level ground and then level it. Once this is done you can then measure from the…
Your spindle should have a Washer #SW1000 between the outer bearing and the Spindle Nut #165686. As this part is typically always reused that is the reason it is not included in the Bearing Kit #BK1-150. Instead we only include the cotter pin and…
Filters
