Hey Deven, thanks for reaching out, and good question. For a 12 volt system, the charge controller can handle one 200 watt panel. For 24v systems it can do two 200 watt panels. So while the kit technically is expandable, with your 12v system, the one…
I'm guessing it is approximately 3-3/8" across if you measured it. Unfortunately there are no options that will slide in because it won't line up correctly, and everything is designed to fit a 3" tongue so it is too wide to mount an…
We don't have a way to look it up but if that 4-way connector came with your 2018 Ford F-150 from the factory then you definitely have the brake controller port. It'll be located below your steering wheel behind the panel on the right. I have…
The only thing I found on your Dexter 70-7 is the Replacement 13" Rotor for Dexter Disc Brakes #K71-631-00 which has 70-7 stamped on it. The #K71-631-00 fits 8,000 lb. Dexter disc brake kits like the #K71-646-2, #K71-646-2-91 or #K71-646-2-90.
The traditional wire colors for brake controller installation are white for ground, black for 12 volt power, red for stoplight switch, and blue for brake output. For more information on wiring in a brake controller check out the help article I…
Hey Wayne, the first thing I would check is the condition of the battery that powers the jack as well as the wiring connections made to it. Lifting a jack is a lot harder than lowering so if there is an issue with the power or wiring it will show up…
Hi Dale, that seal has a 2.312" inner diameter and 3.376" outer diameter which isn't something we carry. Are you sure that is the correct grease seal for your trailer? Unless it is a really old trailer, or home built with mobile home…
Hey Don, thanks for reaching out! I checked out the owner's manual for your 2025 Traverse and according to page 258 it says "if equipped" and there are blunt cut wires that need to be spliced into. This means you'll need to hardwire…
Hello Pat, The 7-Leaf Double-Eye Spring for 8,000-lb Trailer Axles - 24-7/8" #e89FV are our own product, so we're the manufacturer and they are made in China. The Dexter 7-Leaf Double-Eye Spring for 8,000-lb Trailer Axles - 24-7/8" Long…
For a replacement leaf spring you need to know your axle capacity as well as the length of your current leaf springs. You will need to measure from center of one eye to center of other eye on your leaf spring that isn't broken. Since these are…
Hey Darrel, we actually have exactly what you are looking for with the part #TRU52FR which is for a 7k axle and is 25-1/4 inch from eye to eye. This is also a 6 leaf spring as well. The spring you referenced would be too short.
Filters
