Search: bike rack hitch adapter   >   !Camper Jacks   >  

We carry a very handy 2 inch ball mount for this exact application. The part is #D210. The ball mount slides and pins into your hitch and the top receiver will accept 2 inch bike racks and hold them above the ball. The Ball Mount has a 500 lb…

The best 4-way trailer wiring harness we have for your 2019 Subaru Crosstrek is the Curt #C56040 mainly because of the quality and reliability of the converter box. It has the highest amperage rating of all of the options which allows it to be the…

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

The primary difference is a matter of numbers. When installed, the Draw-Tite Class III #76025 will sit so the inside top edge of the receiver tube sits about 13 inches above the ground, and the receiver tube will sit under the bumper so that the…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

The area on the 2017 Chevy Bolt EV that needs to be trimmed is the center, lowest point of the rear fascia that, once trimmed and the hitch installed, won't be visible. The area being trimmed is 3-1/4 inches across and 5 inches deep/tall. I have…

Yes, the Malone 2-Inch Dual Purpose Hitch Receiver Adapter #MPG544 can be used to tow a vehicle using a tow bar in the lower receiver while at the same time using a hitch-mount type bike rack in the upper receiver. You do want to keep in mind that…

Well I hate to be the bearer of bad news, but there is nothing out that is capable of doing that unfortunately. Right now, the only trike bike rack we carry is the SeaSucker Trike Rack for 1 Trike #298-BD1005 which is designed to carry only one…

To use the Stromberg Carlson Bike Adapters, your carrier will need to have the available wheel base for your bikes, and also holes in its mesh that are roughly 5-1/2 inches apart center to center to properly mount the bike adapter plates into the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The Trailer Hitch Adapter #e93YR is the closest extender/riser to the Trailer Hitch Extender #e68YR you found. The adapter does change from the 1-1/4" receiver to a 2" receiver for the accessory. You would need the Reducer #e63YR to get…