Can Air Lift Air Bags be Filled Simultaneously Using a Union Tee

Question

Question:

Can I fill both bags simultaneously by placing a T fitting to the air lines? This way the rear rises equally.

asked by: Ricardo

0

Expert Reply:

Yes, you can simultaneously inflate your Air Lift LoadLifter 5000 Ultimate Air Helper Springs # AL88299 if you use the Air Lift Union Tee for 1/4" Air Lines # AL21838. This will allow you to fill both bags using a single inflation valve.

expert reply by: Robin H

0

Answer 1

Hello Kirt, thanks for reaching out. Unfortunately, the air bag kit from a 2020 F350 will not carry over to a 2023 model. There were a few design changes after 2022, so the 2023 model will require a whole new kit. For the 2023 F350 I recommend the…

view full answer...

Answer 2

Installing the Union Tee #AL21838 with your #AL57575 will tie the pressure of the two air bags together. So yes, a shift in a very heavy load like a truck camper will potentially result in air being forced from one into the other. The reason I say…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 11

Louie, Yes, that is a great question. You do not have to worry about the air bags interfering with your B&W Turnoverball hitch setup. The Firestone Ride-Rite Air Bags with Easy Mount Compressor and In-Cab Control #F84XV are compatible with in-bed…

view full answer...

Answer 12

Hey Jon, I have a solution for you but I would not recommend the Andersen Weight Distribution system part #AN33VR for your 2025 Brinkley Z Air 297. What we have found is that the Andersen system does a decent job with lighter weight trailers but for…

view full answer...

Can Air Lift Air Bags be Filled Simultaneously Using a Union Tee

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching