Hey George. The Power Mountain Tallboy Off-Road Bottle Jack item #PM34FR is only rated for 6-tons but it's not like you're raising up the entire motorhome. Most of the weight is going to be on the back though and since it is a dually, I…
Hello Rhonda, thanks for reaching out. Yes, we do offer both front and rear mud flaps for the 2024 Chevy Colorado Trail Boss with fender flares. For that I recommend the following: - WeatherTech Mud Flaps - Easy-Install, No-Drill, Digital Fit - Front…
Hi Henry; the Power Mountain Tallboy Off-Road Bottle Jack #PM34FR you were looking at will work well for your Cybertruck. This has a 6 ton weight capacity which will be more than enough to handle your truck and a lift range of 8-1/2" to…
Hey Bill, thanks for reaching out! The Optronics Smoke Lens ID Light Bar #OPT55KB doesn't have Lumen or Candela ratings according to my contact at Optronics. I will say that this will be about the equivalent of a light on your vehicle. So there…
Hey Chris, in the instructions for the B and W Turnoverball gooseneck hitch part #BW73FR that you referenced it says that the inner brackets are not needed if the truck has the inner brackets for the OEM hitch already welded to the truck frame. In…
Hey Raymond, since the 5k rated etrailer jack part #e55ZV is rated higher than the 3.5k option you also mentioned it will work a little bit quicker since it won't be working quite as hard. With that said it's not a fast jack by any means. It…
Yes The Ultra Bright LED Flood Light #3371492196 can be used as a backup light when connecting to your reverse blue wire from the 7 plug, but you need to make sure that the circuit can handle the power of the light. Each light runs 6.25 amps, since…
Hey Jeff, I don't see why you could use the Roadmaster diode part #RM-790 the way you mentioned. Sounds like you are looking for a way to have aux lights come on with either a remote switch from your cab or to come on anytime the high beams are…
Hi Frank, While we can get you a brake controller for your 2020 Chevy Colorado, there isn't a plug-in option and harness because the truck doesn't have a plug under the dash. That said, the wires are already run to the cab, so it isn't…
To replace the 10K Hybrid safety cables that came with your Roadmaster Nighthawk tow bar you'll need the kit #RM-674 which comes with 2 of these cables. These are the same design as your current setup and they come with a limited lifetime…
Hey Randy, I wish we had the replacement flush ball you are looking for but at this time Dometic does not offer that as a replacement part. Only solution would be a new 310 like the part #DOM57FR.
Hey George. The Power Mountain Tallboy Off-Road Bottle Jack item #PM34FR is only rated for 6-tons but it's not like you're raising up the entire motorhome. Most of the weight is going to be on the back though and since it is a dually, I…
Hello Rhonda, thanks for reaching out. Yes, we do offer both front and rear mud flaps for the 2024 Chevy Colorado Trail Boss with fender flares. For that I recommend the following: - WeatherTech Mud Flaps - Easy-Install, No-Drill, Digital Fit - Front…
Hi Henry; the Power Mountain Tallboy Off-Road Bottle Jack #PM34FR you were looking at will work well for your Cybertruck. This has a 6 ton weight capacity which will be more than enough to handle your truck and a lift range of 8-1/2" to…
Hey Bill, thanks for reaching out! The Optronics Smoke Lens ID Light Bar #OPT55KB doesn't have Lumen or Candela ratings according to my contact at Optronics. I will say that this will be about the equivalent of a light on your vehicle. So there…
Hey Chris, in the instructions for the B and W Turnoverball gooseneck hitch part #BW73FR that you referenced it says that the inner brackets are not needed if the truck has the inner brackets for the OEM hitch already welded to the truck frame. In…
Hey Raymond, since the 5k rated etrailer jack part #e55ZV is rated higher than the 3.5k option you also mentioned it will work a little bit quicker since it won't be working quite as hard. With that said it's not a fast jack by any means. It…
Yes The Ultra Bright LED Flood Light #3371492196 can be used as a backup light when connecting to your reverse blue wire from the 7 plug, but you need to make sure that the circuit can handle the power of the light. Each light runs 6.25 amps, since…
Hey Jeff, I don't see why you could use the Roadmaster diode part #RM-790 the way you mentioned. Sounds like you are looking for a way to have aux lights come on with either a remote switch from your cab or to come on anytime the high beams are…
Hi Frank, While we can get you a brake controller for your 2020 Chevy Colorado, there isn't a plug-in option and harness because the truck doesn't have a plug under the dash. That said, the wires are already run to the cab, so it isn't…
To replace the 10K Hybrid safety cables that came with your Roadmaster Nighthawk tow bar you'll need the kit #RM-674 which comes with 2 of these cables. These are the same design as your current setup and they come with a limited lifetime…
Hey Randy, I wish we had the replacement flush ball you are looking for but at this time Dometic does not offer that as a replacement part. Only solution would be a new 310 like the part #DOM57FR.
In these days of customer "no service" I am usually disapointed when doing business with people I don't know. It was refreshing doing business with you. I'm impressed!
Rectangle work lights are perfect for enhancing visibility in various applications, from tractors to trailers. They offer bright, focused lighting that can extend over 100 feet, making them ideal for tasks like snow plowing or illuminating loading ramps. Easy to install and versatile, these lights are a reliable choice for any work environment.
Rectangle work lights provide a broad, focused beam that enhances visibility over long distances. They're ideal for tasks requiring precise lighting, such as snow plowing or trailer loading. Their shape allows for easy mounting on various vehicles, making them versatile for different applications.
Rectangle work lights are built to withstand tough environments. Many have been used for years in salt and road slush without issues. They're designed to be robust, making them suitable for outdoor use on vehicles like tractors and trailers.
Yes, rectangle work lights can be used indoors, especially in areas where you need focused lighting without distraction. They're great for illuminating storage areas or inside truck beds. For brighter light, consider replacing the bulb with an LED equivalent.
Rectangle work lights are generally easy to install. They can be mounted on various vehicles and connected to existing circuits. Some users have even customized their setups with magnetic switches for automatic operation, showing their versatility and ease of use.
Rectangle work lights typically require a 15-amp circuit when two are switched together. This ensures they operate efficiently and provide the bright, extended lighting needed for tasks like snow plowing or trailer illumination.
Filters
