Dimensions of PET95FJ With Grommet

Question

Question:

Your side marker lights, do you know measurements of light with the grommet added to the light

asked by: Steven T

0

Expert Reply:

Hey Steven!

I measured the Peterson LED Clearance and Side Marker Light # PET95FJ using a caliper and the measurements with the grommet came out to 1.91" tall and 3.26" wide. Rounded to the nearest fraction on a tape measure, that would come out to 1-29/32"x 3-1/4". What are the dimensions that you're looking for? What kind of project are you working on?

expert reply by: Jerry B

0

Steven T.

8/1/2026

Trying to find a light for my 1998 triton trailer someone stole all the lights at boat ramp

Jerry B.

8/3/2026

@StevenT Wow, I hate to hear that! Hopefully this is the right light for you. Did you confirm that those are the correct dimensions for your trailer or would you like me to find you another one?

Answer 1

Hey Rodney, yes they do! The Peterson PC-Rated LED Clearance and Side Marker Light - Red - Grommet Mount #PET45FJ is what you're looking for. This is the same as the #PET95FJ but with a red lens instead. What kind of trailer are you working on?

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Answer 11

Hey Steven! I measured the Peterson LED Clearance and Side Marker Light #PET95FJ using a caliper and the measurements with the grommet came out to 1.91" tall and 3.26" wide. Rounded to the nearest fraction on a tape measure, that would come…

view full answer...

Answer 12

Hey Rick. Unfortunately that's correct the Wesbar Tail Light 271594 has been discontinued. Our best option for replacing it is the LED Trailer Tail Light item #STL36RB for the passenger side and item #STL37RB for the driver side. The Wesbar light…

view full answer...

Dimensions of PET95FJ With Grommet

Product Page this Question was Asked From

Continue Researching