Yes, it does Mike. There's enough of a gap between the mounting bracket and the back of the lid on the Bright Way Push-to-Test Trailer Breakaway Kit item #3802308, that the lid will open up all the way. What kind of trailer do you have?
It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…
...grab the Mounting Bolts and Hardware for 12" Single Brake Assembly # BRKH12S. This will replace the hardware on a single brake, so you will need two if you are just doing one axle or four if you...
Hi Brandon! For the Dexter 5-Leaf Slipper Spring w/ Flat End for 10,000-lb Trailer Axles - 30-1/2" Long #DX45QR, you will want the Bronze Spring Eye Bushing, 3/4" x 1" x 2-1/2" #14-67. This is a direct replacement for what came in…
...the heavier gauge wire becomes more necessary. On a smaller trailer with a single axle of brakes 12 gauge wire would probably be enough. But for a longer tandem axle trailer I would recommend you run 10 gauge...
Hey Tom. The highest capacity drum brake assemblies we have for a 4 bolt brake flange are the Dexter Electric Trailer Brakes item #23-105-106-09. These are a 6,000 lbs set that are mainly used with AL-KO/Hayes axles. Do you have any part numbers or…
Hey Al, I have a solution for you but we don't have anything that is a direct replacement for the Kodiak 204 caliper including the DeeMax you referenced. . Since Kodiak was bought out by Dexter it seems they discontinued the 204 caliper in favor…
I currently have four different self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes. You can choose from the following: -Terran Axle Electric Trailer Brakes #TX97ZJ (3,500 Axles) -etrailer Electric Trailer…
Hey Graham, thanks for reaching out! Yes, the Norcold RV Mini Fridge w/ Built-In Freezer #NC97VR is compatible with both 12V and 24V power systems, and I've sent in an update to have that fixed on our site - thanks for catching it! Which power…
In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
Hey Mike, I see your confusion there! They are both rated for 2,860lbs at 65 psi. I went ahead and reached out directly to Kenda to make sure we had our information correct, turns out we did not. Both part numbers have the same weight rating for the…
I like the easy of navigation through the site. It only took me a couple of minutes to place my order. Thank You I will shop this sight again in the future.
Filters
