2003 Ford Excursion Vehicle Snow Plows

Hi Stan! The SnowBear Snowplow for 2" Hitches - 82" Wide x 19" Tall #K2AVAL8219 and Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2" #C31018 will definitely work on your 2013 Ford F-250 4x4. We actually have both of these…

Hey Phil. The Custom Mounting Brackets for Detail K2 Snowplows item #K282630 are the correct ones for your 4WD 2018 Chevy Colorado. The brackets are compatible with the following snow plows: Detail K2 Rampage II Snowplow item #K2RAMP8219 Detail K2…

Hey Dean, the Detail K2 Elite Snowplow part #K2AVAL8219ELT that you referenced comes with all of the electrical components it will need to install. It wires to the vehicle battery as well as comes with a wired switch that you would run to the cab of…

Good question! The blade stiffeners that come with the Detail K2 Snowplow #K2AVAL8422 don't necessarily have to be used. I reached out to my contact at Detail K2 who said that the only time that those stiffeners really need to be used is if you…

Hey Gary, great question. Both plows look pretty similar huh? That is because there is only one difference between them, confirmed by Agri-cover. Agri-Cover SnowSport LT Snowplow part #SS98GV it built to be used in both the front and the rear hitch.…

Hey Gary. The Draw-Tite Front Hitch item #65031 is going to mount a bit higher on your 2004 Toyota Tundra compared to the Curt item #31180. The Curt Front Hitch item #31180 is 14-3/4" off the ground when measured from the top of the inside of…

Hello Nathan, Yes, the Custom Mounting Brackets for Detail K2 Snow Plows #K256ZR are the correct custom mounting brackets to mount your Detail K2 Snow Plows on your 2026 Ram 2500 Diesel. In order to install, MUST REMOVE DROP TUBES ON BOTTOM OF FRAME.…

The SnowBear snow plows have two mounting options on your 2019 Ford F-250. One is the brackets #K281530 and the other is the Curt Front Mount Trailer Hitch #C31078. I would choose the front mounted hitch since it will allow you to use other…

The wireless remote of the K2 Detail plow part #K2SUMM8826ELT only controls the up and down function of the plow and now the angle from side to side.

Hey Mike! The Agri-Cover SnowSport 180 Snowplow #SS78GV can be used on a rear hitch. However, it will be up to you to measure your rear hitch to ensure compatibility. The snow plow requires 8" - 16" from the ground to the bottom of your…

Hi Kristian, great question! The etrailer Anti-Rattle Hitch Collar, part #e55YV, works by taking the slack out between your hitch receiver and the shank of your ball mount or hitch-mounted accessory. It clamps around the outside lip of your 2-1/2…

Hey Scott! The etrailer Anti-Rattle Hitch Collar #e55YV is rated for up to 10,000 lbs gross trailer weight and won't reduce the capacity of a properly matched towing setup. As always, your actual towing capacity is determined by the lowest-rated…