Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hello Matt, Thanks for writing in, that’s a great question. I’ve definitely heard the same concerns about the factory leaf springs on these, especially on larger toy haulers like your Wolf Pack. It makes sense to want something that’s going to hold…
view full answer...The outer diameter of the inner tube of the Trailer Valet JXC part #TV64FR is 2 inches.
view full answer...I got my hands on the Removable Xtreme Off-Road Swing-Up Trailer Jack #ARK47FR and was able to determine that it can accept a 2" outer diameter tube inside the mounting tube and has a 5/8" diameter retention pin. If you remove the current…
view full answer...Based on the pictures you attached and the outer bearing measurement you provided, it appears that you have 1-1/16 inch spindle like the BTR EZ Lube Spindle #TRU44FR. This particular spindle is designed for 2,000 pound axles and will use the same…
view full answer...The Stainless Steel Hex Lag Screw #FA74521 contains one 3/8" diameter, 1-1/4" long lag screw.
view full answer...The ARK trailer jack part #ARK57FR uses a dual wheel setup with rubber tires that were designed for getting over off-road terrain which will be much easier to move by hand but the easiest would be the Trailer Valet 5X part #STC-V211 which comes with…
view full answer...Sounds like you need the Replacement Caster Wheel for Ultra-Fab Manual 2" Trailer Jack #UF49-954035. This is designed to fit both the 2" jack as well as the 1-3/4" tube like what you have. Attached is a review video for you to check…
view full answer...The handle on the Ultra Faucets 6" Drinking Faucet #277-000189 does not have to be held down to dispense water, it will continue to flow. The spout of this faucet is not flexible.
view full answer...Sway control is designed to be used in situations where the trailer sways under adverse conditions such as high winds or when large vehicles are passing causing the trailer to become unstable. Sway control also helps if you have to maneuver suddenly.…
view full answer...To replace the broken foot base from your Thule Tracker Roof Rack you will just need the part #753-2149. This includes 1 foot base that will install with the track on your original kit.
view full answer...To verify if your 2021 Ford E-450 cutaway chassis for your Class C motorhome is pre-wired for a brake controller you will need to remove the storage slot in the top of your dash. I have included a install video below that shows how to remove the…
view full answer...We have the bearing part #387A which is over 2 inches in inner diameter and is seen on 10,000 lb axles but I'd have to know exactly what your spindle dimensions are to know for sure what you'd need. If you can use a digital caliper like the…
view full answer...