Availability of 14 inch Trailer Wheel with 4 Bolt Pattern

Question

Question:

I am needing a rim for a spare for my vintage car trailer. Is there any way to cross reference the number stamped on my existing rims? The number is T14X600T. No brand name stamped on rim. They are 14inch 4-lug star type rims.

asked by: Roger F

0

Expert Reply:

I can't find anything that matches the number you listed, but if the 14 inch wheel you need has the vintange style of 4 bolt pattern where the bolt holes are 9.44 inches apart then the part # AM20312 would be what you would need. Since this is the only 4 bolt style wheel we have that is 14 inch in diameter this would be our best option.

expert reply by: Jameson C

0

Doug G.

8/9/2020

looking for a14 inch wheel would the dexstar wheel fit 1977 jacyco camper onoly need one for a spar

Jon G.

8/19/2020

I'm not sure what wheels your 1977 Jayco Camper has but if it matches the specs that Jameson mentioned then the Dexstar # AM20312 will fit.

Answer 1

You likely can change the hubs on your trailer to give you a more common bolt pattern. To determine the correct fit you will need to pull one of your hubs and get the bearing number printed on the face of the inner and outer bearing. If you are…

view full answer...

Answer 2

We have the Dexstar Vintage Steel Wheel available in a 15"x5" #AM20395. Both use the 4 on 9.44" bolt pattern. We do have the Karrier ST205/75R15 Radial Trailer Tire #AM10244 and Westlake ST225/75R15 Radial Trailer Tire #LHWL304 that…

view full answer...

Answer 3

We have one 14" rim with a four-bolt pattern. It's the Dexstar Vintage Steel Wheel w/ +5 mm Offset - 14" x 5-1/2" Rim, part #AM20312. This is a vintage rim with a 4 on 9.44" bolt pattern, a 5-1/2" width, and a 1/2"…

view full answer...

Answer 4

Dexstar Vintage Steel Wheel #AM20395 does just have the star shape and not a large circle. It is the only wheel that we carry that has the 4 on 9.44 inch bolt pattern. Based on the measurements of the wheels you currently have, this wheel would not…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Availability of 14 inch Trailer Wheel with 4 Bolt Pattern

Continue Researching