Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The spray in bed liner of your 2018 Ford F-250 will protect the aluminum bed from the steel rails when you install Curt Custom 5th Wheel Installation Kit for Ford part #C16428-204 so you won't need to use the galvanic isolator tape on the bottom…
view full answer...The 334850 part number you mentioned refers to the Replacement Control Switch #LC334850. This particular unit replaces the control switch assembly for certain Lippert Tread Lite RV Steps ( #LC353542, #LC353543, #LC353620, or #LC353621).
view full answer...The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…
view full answer...Thank you for providing photos of your vehicle connector. The Ford F-450 cab and chassis that is the basis for your Class C motor home is used for a range of different vehicle applications and Ford includes a number of roughly similar connectors to…
view full answer...You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…
view full answer...Yes you can use the Lippert Solid Stance RV Step Support Kit #LC96BJ. This support kit will work with steps 5" to 14" off the ground, and measures 22-3/4" wide x 2-5/8" tall x 4-1/2" deep when folded. Attached is a review…
view full answer...I looked up as much info as I could on your 2018 grey wolf 26DBH travel trailer and based on the GVWR of the trailer and the fact it's a tandem axle trailer you would have 3 inch axles and the correct over-under lift kit to move the axles to…
view full answer...The Replacement Foot Pad #LC324269 that you referenced uses (and includes) a threaded 7/16" bolt for mounting. The mounting hole itself is just about 1/2" in diameter.
view full answer...I understand your concern. I called Lippert to verify that the 132 Ft-lb of torque and use of Locktite is still valid. They said that was the requirement and there were no alternative instructions. The assumption is that this is the method they used…
view full answer...The replacement foot for the rear Lippert jack on the Lippert Ground Control 3.0 System is #LC377962. You will also need a replacement 3/8 x 3 inch pin, #LC225598, to connect the foot to your jack.
view full answer...If you didn't have to install the pigtail that came with the Lippert Components Kwikee 25 Series Triple Electric Step #LC3658373 then you would want to test the wire functions of the current pigtail (with the 4 prong connector) that is installed…
view full answer...If you check out the diagram I attached you will see how the steps should get wired up. What I would first do is verify that you have voltage in all of the right places on your steps to determine if the module needs to be replaced with the #LC301702.…
view full answer...