Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Replacement Support Bow part #TX578101-BOW measures 62-1/4" long from end to end. This bow is designed to be used with the TruXedo Lo Pro QT Soft Roll-up Tonneau Cover part #TX578101 which is a fit for the following: 2004 - 2007 Ford F-150…
view full answer...For your Truxsport Tonneau on your 2011 Ford F-350, you will want the Replacement Truxedo Shur-Bond Velcro Brand Fastener #TX1117876. This is a 1 inch wide strip of the hook side of the velcro. The mating loop piece will already be on the tonneau…
view full answer...To replace the Velcro strips for the TruXedo Lo Pro Tonneau Cover #TX577601 on your 2008 Ford F-150 you just need the part #TX1115174. Just keep in mind that you will need to cut the strip down to size as it's technically made for the 6-1/2 foot…
view full answer...For your Truxedo Truxport tonneau cover the correct velcro you need for the side rails is the part #TX1117876 and you'd be set. This comes with screws to install and would need to be cut down to the size you need.
view full answer...The TruXedo TruXport Soft, Roll-Up Tonneau Cover that fits a 2010 Ford Ranger with a 6 foot bed is part #TX250101 and the correct tarp is the Replacement Tarp for TruXedo TruXport Soft, Roll-Up Tonneau Cover #TX2501-CVR. Though we do not have any…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…
view full answer...From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…
view full answer...Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…
view full answer...Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…
view full answer...Related Searches
Filter Your Search
Contact and Help