Since the slot dimensions and capacity of different brands of E-Track are identical, really the only differences are the finish and the lengths the tracks are sold in. If you're using the E-Track in an area where aesthetics are important, you can…
In order to replace the Bargman L-200 Door Lock Set, I recommend taking a look at the Global Link RV Entry Door Locking Latch Kit part #295-000019 for black, part #295-000021 for white, or part #295-000002 for chrome. This system has a sturdy steel…
The 3/8 inch chain would not be a problem but the hook could be depending on its size. If you can't run the chain through backwards or there are hooks on both ends of the chains you have then the hook needs to be less than 1-3/8 inches high and 2…
Tie-down anchors for truck bed stake pockets like the Erickson Retractable Tie-Down Anchors #EM01003 referenced in your question are designed to fit most truck bed stake pockets. I have attached an image showing the dimensions of this product so you…
The 3-1/4 inch diameter hole to install the part #RR5K is the correct dimension to use. We actually even had a customer come back and say they did it with a 3 inch hole saw. I attached a link to the install video you mentioned as well.
The Brophy Pintle Hook part #BR27FR will accept any lunette ring with an inner diameter equal to or greater than 2-1/2" which will have a thickness of 1-1/2". This is the correct way to determine compatibility between a pintle hook and…
The reverse light pin on a traditional 7-way trailer connector, like part #PK11893 or a factory connector if that's what you have on your 2018 Ram, is the center pin. Take a look at the picture I attached that shows all the pin functions. To add…
We do actually have Dexter electric drum brakes in your required 10 x 1-1/2-inch size, parts #K23-473-00 and #K23-472-00, which are right- and left-hand, respectively. These are complete bolt-on (4-bolt) replacements that fit wheels diameters from…
There's not a wiring diagram for the ARC Lighting Load Resistor for LED Lights - Quick Splice #ARC22VR however the installation is pretty simple. All you're going to need to do is take one end of the resistor and connect it to the ground on…
Yes, the Bearing Kit for #84 Spindles part #BK2-100 is correct for your Lippert Trailer Idler Hub part 122098. I confirmed this with Lippert for you as well.
Going by the colors that you mentioned, it sounds like you have the typical set-up, green wire for right turn and brake, white wire for ground, yellow wire for left turn and brake, brown with green wire for right side running lights, and brown with…
On a 4-Way flat trailer wiring harness, white is the ground, brown is running lights, yellow is left turn signal and green is right turn signal. It sounds like your trailer has a wishbone harness. A wishbone harness splits the running light circuit…
Filters
