Review of etrailer E Track - E-Track Rails 4 Pack - e62VR

content loading

Customers compare e62VR to these similar products




Products Featured in this Video



etrailer E Track - E-Track Rails 4 Pack - e62VR Review


Jeff: Hello everybody. This is Jeff at etrailer.com. Today, we're going to take a look at the etrailer eight foot-long galvanized steel, horizontal E-track for a quantity of four. Now this E-track system will provide the tie-down points for securing your cargo in your trailer or your truck or your van. It is designed for use with E-track straps, anchors and accessories, which we do sell separately on our website. And they have many different accessories that'll clip in here.

These are 94 inch long sections. They have multiple slots that can be mounted on either the floor or horizontally on your wall. They are a 12 gauge steel construction with a galvanized finish, which is corrosion-resistant. And what I wanted to show you is, let me just zoom in here, I happen to pull one of the E-track accessories to show you what we're talking about when we say E-track and basically this just happens to be a loop, actually has a clip to it, so you can hook your tie-down straps to this if you want. But the E-track system if you notice has this lever right up at the top, so what you want to do is when you pick the slot, you want to install it in.

Yep. Just pull down on that lever, just like that. And that'll allow you to put it up in there, move the bottom here, let it go. And it'll lock it into place. So it's locked in at the top and at the bottom, and you can hook your tie-down strap right to this.

So what's nice about it, it makes it very easy to move. So if you just want to remove it and you can move it right down here, flip it in and you're ready to go. If you need to move it too a little bit closer, just like that. So clips in and out very quickly and easily. Now to install this track, it's very easy to do, use just screws or rivets.

Now those are not included. Now, if you do install this onto wood, we do recommend wood screws. If you put it into sheet metal, we would recommend the sheet metal screws. The diameter of these mounting holes that are all along the top and the bottom, they are quarter inch diameter. And the distance between these holes is two inches center to center.Now this track can also be cut to the size you need, and it is made in the USA. Few specs on this, the quantity for this part number is four 94 inch long E-track sections, and I just want to give you the measurements on this. So if we go all the way from one end to the other is your 94 inch long, the width on it, one side to the other is right at four and 15/16 of an inch, so just under five inches wide. And the height after it's installed is about a half inch tall. Now the maximum load or break strength on this is 6,000 pounds, and that is per track. The safe working load limit is 2000 pounds per track, but that should do it for the review on the etrailer eight foot long galvanized steel horizontal E-track for a quantity of four.


Questions and Comments about this Video

Info for this part was:

Employee Jeff D
Installed by:
Jeff D
Employee Jacob T
Video Edited:
Jacob T

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.