Hi Bob! The TowSmart Trailer Hitch Receiver - Custom Fit - Class III - 2" #TS56VR installs on your 2023 Toyota Highlander in the exact same way as the other hitches we have available for it. With that said, the 10 out of 10 difficulty and 2 hour…
Hi David! We do have a plug in wiring harness for your 2024 Toyota Highlander XLE with the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C56RV. This is fully plug and play and will use that square port/plug you already…
For a 4-way wiring harness for your 2022 Toyota Highlander Platinum Hybrid without the tow package you need the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #TK99FR. When it comes to wiring, we have found Tekonsha to be the most…
The 2 easiest ways to tell if your 2020 Toyota Highlander XLE has the factory tow wiring is to either check behind the paneling next to the 3rd row seating on the driver's side to see if a connector is there that the Curt #C56RV module plugs…
Good question, and it is not a necessity for your car to have a 4-way flat trailer connector in order to use the Kuat Piston Pro X bike racks. The 4-way connector that plugs in between the bike rack and the 4-way on your car (if you had one) comes…
Hi Gary! We have exactly what you are looking for with the Curt T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector #C28DQ. This is a plug and play harness, with one wire that does need to be run up to the battery for power, and the…
Hey Scott, the backspacing for the wheel of the Kenda Tire and Wheel part #KE46JV that you referenced is 3 inches. This is based on fact the wheel is 5 inches wide but then you have to add in an inch for the flange lip and then just divide by two.…
Hey David, sorry about the confusion but if you have a 2500 model you do need to drill but if you have a 3500 you do not. So since you have a 2500 you would need to do some drilling to install.
Hey Mike, to pick out the correct hitch for your 2023 Mercedes Sprinter 2500 high roof comes down to what style of rear bumper your vehicle has. If it's a standard bumper the Curt part #C13388 is a really great option. If it has a factory step…
To carry the two pieces of your modular kayak you could use a carrier like the Thule Compass part #TH890000 which you could carry on either side of. This can be used to carry two kayak but in your case you'd just put each piece on either side of…
I spoke to my contact at Curt and they informed me that the reason you are hearing the buzzing noise and the third brake light is flashing when using the Vehicle to Vehicle Tail Light Converter part #C56196 is because the green and yellow output…
We have a coiled 7-way to 5-way like with the part #C57271 for a 60 inch long setup. We don't have a 5-way to 5-way though so you'd have to cut off the 7-way and wire in a new 5-way like with the #HM47910.
Filters
