Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer jacks. I'm…
view full answer...Hey Brent! I would mount the Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR on the outside as close to the corners as possible. If you mount them in the center of the trailer they won't add nearly as much stability. If you're worried about…
view full answer...Hey Sam, we recommend 1/2 inch grade 8 bolts and nuts for securing your wheel to the Curt spare carrier part #C31006. I wish we sold them but since we do not you'd need to check with a local hardware store.
view full answer...Good question, and we have asked the manufacturer, Ark, this very same question, and they have said there is not any weight rating for the Ark Drop Down Corner RV Stabilizer Jacks - 33" Long Corner Steadies #ARK77FR. They say the reason they…
view full answer...I've attached a dimensional drawing for the Ark XO Drop Down Corner RV Stabilizer Jacks #ARK87FR, which displays the measurements in mm and inches. If you need anything else please let me know and I'd be happy to help.
view full answer...The Ark Drop Down Corner RV Stabilizer Jacks - 33" #ARK77FR is the same as their part number: XODDS850BUS.
view full answer...The Ark Drop Down Corner RV Stabilizer Jacks - 2-1/2' Long Corner Steadies - Qty 2 #AR94FR are 19" long at their shortest and extend 11" to give you up to 30" to keep your camper stable. If you were referring to the brackets and…
view full answer...You sure can! The handle is 22-1/8 inches long overall, the remaining dimensions can be seen the provided photo.
view full answer...Hi Mike; the Ark Drop Down Corner RV Stabilizer Jacks #ARK77FR can be used in three different positions. At 30° and 60° they act as non-rated stabilizers. At 90° they have the 1,929 lb rating.
view full answer...My contact at Ark said the mounting plate for the Ark XO Drop Down Corner RV Stabilizer Jacks #ARK87FR can be installed by modifying it and using countersunk bolts. Attached is a photo of the dimensions for you to reference (117mm long x 72.50mm wide…
view full answer...Hello Daniel, thanks for reaching out. The Ark Drop Down Corner RV Stabilizer Jacks #AR94FR are 19" long when fully retracted. They have 11" of travel so they go out to 30" long overall when fully extended. I edited a picture for you…
view full answer...The Replacement Standard Dual Rack Repair Kit for Lippert RV In-Wall Slide-Outs - Fixed Side, #LC84FR is the left side of the slide-out as looking at it, facing it, from the outside. The float side, #LC26VR, will of course be the right side as facing…
view full answer...