How Short Do the Ark Drop Down Corner Jacks Compress

Question

Question:

How long are these jacks when they are collapsed shortest ? Item # AR94FR

asked by: George S

0

Expert Reply:

The Ark Drop Down Corner RV Stabilizer Jacks - 2-1/2' Long Corner Steadies - Qty 2 # AR94FR are 19" long at their shortest and extend 11" to give you up to 30" to keep your camper stable. If you were referring to the brackets and the folded up to the trailer dimensions, the brackets are approximately 5-1/2" tall.

expert reply by: Erik B

0

Answer 1

You sure can! The handle is 22-1/8 inches long overall, the remaining dimensions can be seen the provided photo.

view full answer...

Answer 2

Hey Brent! I would mount the Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR on the outside as close to the corners as possible. If you mount them in the center of the trailer they won't add nearly as much stability. If you're worried about…

view full answer...

Answer 3

The Ark Drop Down Corner RV Stabilizer Jacks - 33" #ARK77FR is the same as their part number: XODDS850BUS.

view full answer...

Answer 4

Good question, and we have asked the manufacturer, Ark, this very same question, and they have said there is not any weight rating for the Ark Drop Down Corner RV Stabilizer Jacks - 33" Long Corner Steadies #ARK77FR. They say the reason they…

view full answer...

Answer 5

Hi Mike; the Ark Drop Down Corner RV Stabilizer Jacks #ARK77FR can be used in three different positions. At 30° and 60° they act as non-rated stabilizers. At 90° they have the 1,929 lb rating.

view full answer...

Answer 6

Hello Daniel, thanks for reaching out. The Ark Drop Down Corner RV Stabilizer Jacks #AR94FR are 19" long when fully retracted. They have 11" of travel so they go out to 30" long overall when fully extended. I edited a picture for you…

view full answer...

Answer 7

Hey Bob. The Ark Drop Down Corner RV Stabilizer Jacks item #AR94FR have to be welded to your Grand Design's frame. They're designed to be mounted directly below your frame so there's no way to bolt them to it. The Stabilizer Jacks item…

view full answer...

Answer 8

I have attached a few photos for you with all the dimensions we have for the Ark Drop Down Corner RV Stabilizer Jacks part #AR34FR. That said, Ark is an Australian company so the measurements are in metric, millimeter to be specific so you may need…

view full answer...

Answer 9

The weld-on mounting bracket for the ARK #AR94FR Drop Down Corner RV Stabilizer Jacks measures 4-5/8 x 2-7/8 inches. The bracket has holes for the hardware that attaches the jack to the brackets. The holes are 2-7/8 inches apart on center. I've…

view full answer...

Answer 10

I checked with Ark and they informed me that their Drop Down Corner Stabilizer set part #AR34FR will work great on your 2015 Passport Grand Touring Ultra Lite but these jacks do not have a weight capacity. This is what they sent me: "The #AR34FR…

view full answer...

Answer 11

We don't offer a combination leveler/stabilizer jack, but if you're wanting something in a stabilizer jack that is very sturdy, you can't go wrong with the ARK Drop Down Corner stabilizer jacks. They're available in a powder coat or a…

view full answer...

Answer 12

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

How Short Do the Ark Drop Down Corner Jacks Compress

Product Page this Question was Asked From

Continue Researching