Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…
view full answer...The dimensions you have are nearly identical to the CE Smith #CE19504-2 you looked at. However, these are designed for 14" wheels. For 15" wheels you would need the Fulton #F008585-2. These are slightly longer and taller at 10-1/4"…
view full answer...Typically when a converter like the Brite-Lite #RM-732 fails, and especially when it happens more than once, it is the result of a short somewhere in the wiring that needs to be addressed it will most likely happen again. Before replacing the…
view full answer...Hello Jeff, thanks for reaching out, and thanks for providing all that info, it really helps. I looked up that Magic Tilt part number PG1090. It is a UFP model A-60 which is super common and we do have a good replacement for this. Take a look at the…
view full answer...I spoke with Demco about the Demco Master Cylinder Adapter for Power Bleeder #DM10142 and they can't confirm that it'll directly fit because it would primarily depend on the size of the cap for your actuator. However they did go on to mention…
view full answer...Yes, the Replacement Solenoid Adapter Fitting for Titan Model 10 Brake Actuators, part #T4750200, is for pre-2000 Titan Model 10 brakes. If you have a newer Titan Model 10 brake, you will use the Orifice Connector for Titan Actuators Item #T1209800.…
view full answer...Hi again David; since TDE is no longer around replacement brake pads are not available for the 46304. However, to avoid complete replacement we have found that the Kodiak Disc Brake Caliper #KDBC225DAC will work as a replacement for the 46304. If you…
view full answer...I have good news, our trailer jack that has a 2 inch outer diameter part #DL74MR would fit and work well. While it has a 1,000 lb weight capacity that does not mean 1,000 lb total trailer weight capacity. That capacity is the tongue weight capacity…
view full answer...Nick, absolutely. Many vanlifers wire the Velit 2000R 12V AC Unit #VE87QV so it runs while the alternator tops off the batteries. It keeps the living space cool while driving long stretches, and when you park, your bank’s already partly replenished.…
view full answer...You're not going to have any problems mixing Dexter and Lippert components on trailer axles over 10k-lbs in the same manner as below 10k-lbs as long as the measurements on the replacement parts are the same- i.e. bearing sizes are the same, etc..…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...The Aluminum HWT Hi-Spec Series 03 Mod Trailer Wheel - 15" x 6" Rim - 6 on 5-1/2 Item #AM22646 do not come with center caps or lug nuts. I recommend the Trailer Wheel Center Cap, Chrome, 4.25" Pilot Size Item #425EZ for your center…
view full answer...