Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Robert, thanks for the information. To add rear stabilizer jacks to your dump trailer, I recommend a pair of the Square Direct Weld Jack w/ Footplate item #TJD-8000S. This jack has a 7,000 lbs capacity and is sold individually so you'll need…
view full answer...We prefer the Hydrastar Actuator part #HBA16 as it is the most reliable and works the best. Rarely do we ever get emails or calls for help troubleshooting problems with this actuator and is the one our installers like the most so I would recommend it…
view full answer...Hey Ray, thanks for reaching out. If you are set on placing the propane tank inside the toolbox, it can be done safely as long as the box is properly vented at the bottom. Propane is heavier than air, so if there is ever a small leak it will settle…
view full answer...We don't have a way to look it up but if that 4-way connector came with your 2018 Ford F-150 from the factory then you definitely have the brake controller port. It'll be located below your steering wheel behind the panel on the right. I have…
view full answer...Hi Mike! We do have the Replacement Rod and Nut for Ram Square, Direct Weld Jacks - 12K #TJD-12000-RODNUT for your jack (I looked it up on Big Tex's website and it is a 12k Ram jack), but that is the only replacement part currently available. If…
view full answer...I contacted the manufacturer about the lengths for these stabilizer jacks and have included the information they were able to provide me. The Ark Drop Down Corner RV Stabilizer Jacks #ARK34FR are 422 mm (16.6") collapsed and 600mm (23.6")…
view full answer...The max amperage draw of the MaxxAir MaxxFan Mini RV roof vent part #MA00-04401M that you referenced is 5 amps.
view full answer...Hello Ron, I reached out to Lionshead to see if I can get the 13" Liger wheel added to the site, they informed me that they do not make the Liger in a 13". The closes thing we have to the Liger in a 185/80R13 is the Taskmaster Provider…
view full answer...We do have a lift kit for your Lippert 7K torsion axle but the Dexter Torflex Lift Kits like part #K71-725-02 are designed to fit specific Dexter torsion axles. For example, the above mentioned kit will only fit a #12 Torflex axle that has a 5,500 -…
view full answer...No, I am sorry there is no alternative to the Drop Leg for Lippert Power Jack - 8-11/16" Tall - 9" Diameter Footplate item #LC405217. The jack manufacturer's notch their tubes and have different diameters so they can't be used…
view full answer...Hey Mike, the Roadmaster Quick Foot Assembly Jack Extender part #RO84FR that you referenced was designed to fit 2 inch diameter inner jack legs. The inner diameter of the foot is right at 2-1/8 inches.
view full answer...The Buyers Products 50 Ton Air Compensated Pintle Hook part #337PH50 measures 2.38" deep by 3" wide. The inner eye diameter is 1.60" wide and 1.37" tall. I contacted Buyers and this hook uses a standard Lunette ring.
view full answer...