Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Advent Air Rooftop RV Air Conditioner #ACM135C does not require a mounting bracket to install, just a 14-1/4" x 14-1/4" opening and a framed with 3/4" lumber, as you can see by the accompanying cut out I added from the…
view full answer...Your trailer must have free backing brakes if you have never used the surge brake actuating coupler reverse lockout. If you did not have free backing brakes, your brakes would most likely brake even if they didn't lock up when you back up…
view full answer...Did you have a 4-pin connector that had 5 wires or was it a 5-pin connector? There is a big difference since you normally see a 5-pin connector on a boat trailer with the 5th pin used for an electric reverse lockout solenoid on a brake actuating…
view full answer...Yes, the Demco #40716-15 Hydraulic Brake Kit will fit your needs for a 10" X 2.5" assembly. When measuring the drum use inside measuerments as shown in the attached photo. You will just want to confirm your flange bolt pattern is 4 on…
view full answer...The Kodiak Dacromet Disc Brake Conversion Kit, item #K2HR35D, would be a good choice for conversion to disc brakes on your boat trailer. We have not had the opportunity to do a video installation for the disc brake conversion yet, but I will go…
view full answer...You will wire a load resistor into the wiring of each light socket that has an LED bulb and flashes. So basically you will need to wire a load resistor into any bulb that blinks or has a dual intensity feature that lights up when the brakes,…
view full answer...The main difference between a "D" (bias) tire and an "R" (radial tire) is how they are constructed. The cords inside a bias ply tire run at a 32 degree angle to the direction of travel whereas the cords on a radial tire run at a…
view full answer...What you would need is a switch like the #D16740, an isolation solenoid part #PK5231201 and some wire like #12-1-1 (sold by the foot). You'd run wire from the positive post of the battery to the terminal on the side of the solenoid and then on…
view full answer...I recommend the Fulton Hi-Mount Spare Tire Carrier #FHDSTC0101. This fits 4 to 6 lug wheels up to 16-1/2" diameter. I have included some images below showing how the carrier was mounted to the floor of the trailer angle iron to secure it to the…
view full answer...I have a solution for you but The etrailer Spare Tire Carrier for Trailer with Angle-Iron Railing - Clamp On #e99045 will not fit your 2.5 inch angle iron. I recommend The Fulton Hi-Mount Spare Tire Carrier - Fits 4- and 5-Lug Wheels #FSTC1000301.…
view full answer...It sounds like this trailer has a 6" tall frame, which presents an issue since almost all of the spare tire carriers we have available are designed to fit on trailer frames no more than 5" tall, however I may have a solution that will work…
view full answer...The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…
view full answer...Filter Your Search
Contact and Help