Comprehensive Review: Ultimate Trailer Jack Video

I do have an option for you but I don't have any way to reduce the ground clearance of your existing a-frame jack . That said, what you can do to fix this issue is replace your existing jack with the Ultimate Trailer Jack part #322-RDJ-2K. The…

I reached out to my contact at Demco who was able to supply me with the attached dimensional photo of the Demco A-Frame Trailer Coupler #DM14793-95.

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

Hi Rob; the lifetime warranty covers the LEDs in the Optronics LED Combination Trailer Tail Lights #TLL160RK. Assuming you buy them through us, you would be able to call our customer service if one of the LED lights failed and we would get you a…

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…

You are correct, the nut and washer of the 2 inch hitch ball #40083 are zinc coated whereas the rest of the ball is stainless steel.

The Demco A-Frame Coupler #DM14791-97 will fit the fairly standard 50 degree A-Frame, which you do look to have. This will definitely extend farther than your current coupler and will measure 7-1/2" long (roughly) from where the A-Frame will…

The easiest way to power your electric jack off of the 7-way and/or the battery is to install the Trailer Wiring Junction Box - 7 Terminals item #3375601100 and connect your jack to the 12v circuit that your battery would also be connected to. This…

Yes, you will be able to replace your stock coupler with the Demco 50-Degree A-Frame Trailer Coupler #DM13205-95 as long as you have a standard a-frame trailer. I attached a picture below of the dimensions below so you can see if it would work for…

No you should not have constant power on the brake output pin, the blue wire should only have power with the brake pedal depressed in the vehicle or the brake controller manual override is activated. If the blue wire has a constant 12V then it is an…

Since you are limiting your trailer to 10000lbs, and the average tongue weight is 10-15% of the trailer weight, you are looking at 1000-1500lbs tongue weight. With that said it is a good idea to use a jack with a larger capacity as it will be able to…

I have attached for you below a photo with the dimensions of the weld-on plate for the Ark Drop Down Corner RV Stabilizer Jack Kit part #ARK94FR. The plates are 117mm long x 72.50mm wide or 4.6" long x 2.8" wide.